• There are no items in your cart
We noticed you’re not on the correct regional site. Switch to our AMERICAS site for the best experience.
Dismiss alert

BS 8110-2:1985

Superseded

Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by

STRUCTURAL USE OF CONCRETE - PART 2: CODE OF PRACTICE FOR SPECIAL CIRCUMSTANCES

Available format(s)

Hardcopy , PDF

Superseded date

16-04-2010

Language(s)

English

Published date

01-01-1985

Committees responsible
Foreword
Section 1. General
1.1 Scope
1.2 Definitions
1.3 Symbols
Section 2. Methods of analysis for the ultimate limit
           state
2.1 General
2.2 Design loads and strengths
2.3 Non-linear methods
2.4 Torsional resistance of beams
2.5 Effective column height
2.6 Robustness
Section 3. Serviceability conditions
3.1 General
3.2 Serviceability limit states
3.3 Loads
3.4 Analysis of structure for serviceability limit states
3.5 Material properties for the calculation of curvature
     and stresses
3.6 Calculation of curvatures
3.7 Calculation of deflection
3.8 Calculation of crack width
Section 4. Fire resistance
4.1 General
4.2 Factors to be considered in determining fire resistance
4.3 Tabulated data (method 1)
4.4 Fire test (method 2)
4.5 Fire engineering calculations (method 3)
Section 5. Additional considerations in the use of
           lightweight aggregate concrete
5.1 General
5.2 Cover for durability and fire resistance
5.3 Characteristic strength of concrete
5.4 Shear resistance
5.5 Torsional resistance of beams
5.6 Deflections
5.7 Columns
5.8 Walls
5.9 Anchorage bond and laps
5.10 Bearing stress inside bends
Section 6 (deleted)
Section 7. Elastic deformation, creep, drying shrinkage
           and thermal strains of concrete
7.1 General
7.2 Elastic deformation
7.3 Creep
7.4 Drying shrinkage
7.5 Thermal strains
Section 8. Movement joints
8.1 General
8.2 Need for movement joints
8.3 Types of movement joint
8.4 Provision of joints
8.5 Design of joints
Section 9. Appraisal and testing of structures and
           components during construction
9.1 General
9.2 Purpose of testing
9.3 Basis of approach
9.4 Check tests on structural concrete
9.5 Load tests of structures or parts of structures
9.6 Load tests on individual precast units
Appendix A Bibliography
Index
Publications referred to

Gives recommendations for the design and construction of structural concrete that arise in special circumstances.

Committee
CSB/39
DevelopmentNote
Supersedes BS CP110-1(1972). (08/2001) Supersedes 81/15604 DC and 86/12217 DC (10/2005) Supersedes 05/30135244 DC. (12/2005) Reviewed and confirmed by BSI, March 2008. (02/2008) Inactive for the new design. (11/2008)
DocumentType
Standard
Pages
68
PublisherName
British Standards Institution
Status
Superseded
SupersededBy
Supersedes

05/30136143 DC : DRAFT JUL 2005 BS 5628-2 - CODE OF PRACTICE FOR THE USE OF MASONRY - PART 2: STRUCTURAL USE OF REINFORCED AND PRESTRESSED MASONRY
ESI 43-4 : ISSUE 2 AMD 1 DESIGN OF FOUNDATIONS FOR STEEL TOWERS FOR OVERHEAD TRANSMISSION LINES AT 132kV AND HIGHER VOLTAGES
BS 5061:1974 Specification for cylindrical forage tower silos and recommendations for their use
BS 5628-2:1985 Code of practice for use of masonry Structural use of reinforced and prestressed masonry
17/30349707 DC : DRAFT AUG 2017 BS 5975:2018 - CODE OF PRACTICE FOR TEMPORARY WORKS PROCEDURES AND THE PERMISSIBLE STRESS DESIGN OF FALSEWORK
BS 5911-103:1994 Precast concrete pipes, fittings and ancillary products Specification for prestressed non-pressure pipes and fittings with flexible joints
BS 812-120:1989 Testing aggregates Method for testing and classifying drying shrinkage of aggregates in concrete
DD ENV 1992-1.1 : DRAFT MAY 1992 EUROCODE 2: DESIGN OF CONCRETE STRUCTURES - GENERAL RULES FOR BUILDINGS (TOGETHER WITH UNITED KINGDOM NATIONAL APPLICATION DOCUMENT)
BS 5950-8:1990 Structural use of steelwork in building Code of practice for fire resistant design
98/103075 DC : DRAFT APRIL 1998 CODE OF PRACTICE FOR MACHINE LAID IN SITU EDGE DETAILS FOR PAVED AREAS
BS 6374-5:1985 Lining of equipment with polymeric materials for the process industries Specification for lining with rubbers
BS 6229:2003 Flat roofs with continuously supported coverings. Code of practice
BS 5975(2008) : 2008 CODE OF PRACTICE FOR TEMPORARY WORKS PROCEDURES AND THE PERMISSIBLE STRESS DESIGN OF FALSEWORK
BS 6349-2:1988 Maritime structures Design of quay walls, jetties and dolphins
BS 8297:2000 Code of practice for Design and installation of non-loadbearing precast concrete cladding
BS 5911-3:2002 Concrete pipes and ancillary concrete products Specification for unreinforced and reinforced concrete manholes and soakaways (complementary to BS EN 1917:2002)
BS 8202-1:1995 Coatings for fire protection of building elements Code of practice for the selection and installation of sprayed mineral coatings
07/30160560 DC : DRAFT JAN 2007 PD 5500 AMD 2 - SPECIFICATION FOR UNFIRED FUSION WELDED PRESSURE VESSELS
BS 6349-3:1988 Maritime structures Design of dry docks, locks, slipways and shipbuilding berths, shiplifts and dock and lock gates
BS 7361-1:1991 Cathodic protection Code of practice for land and marine applications
BS 5911-4(2002) : 2002 CONCRETE PIPES AND ANCILLARY CONCRETE PRODUCTS - PART 4: SPECIFICATION FOR UNREINFORCED AND REINFORCED CONCRETE INSPECTION CHAMBERS
BS 5628-2:1995 Code of practice for use of masonry Structural use of reinforced and prestressed masonry
BS 5628-2:2000 Code of practice for use of masonry Structural use of reinforced and prestressed masonry
BS 5628-2:2005 CODE OF PRACTICE FOR THE USE OF MASONRY - PART 2: STRUCTURAL USE OF REINFORCED AND PRESTRESSED MASONRY
BS 1217:1997 Specification for cast stone
BS 6180:1999 Barriers in and about buildings. Code of practice
BS 6349-4:1994 Maritime structures Code of practice for design of fendering and mooring systems
BS 5950-2:1992 Structural use of steelwork in building Specification for materials, fabrication and erection: hot-rolled sections
PD 5500:2003 Specification for unfired fusion welded pressure vessels
BS PAS 68(2007) : 2007 SPECIFICATION FOR VEHICLE SECURITY BARRIERS
BS 4076:1989 Specification for steel chimneys
BS 5911-200:1994 Precast concrete pipes, fittings and ancillary products Specification for unreinforced and reinforced manholes and soakaways of circular cross section
BS PD5500(2006) : 2006 SPECIFICATION FOR UNFIRED FUSION WELDED PRESSURE VESSELS
BS 5628-1:2005 Code of practice for the use of masonry Structural use of unreinforced masonry
BS 5950-1:2000 Structural use of steelwork in building Code of practice for design. Rolled and welded sections
BS 8110-1:1997 Structural use of concrete Code of practice for design and construction
BS 6180:1995 Code of practice for barriers in and about buildings
BS PAS 68(2010) : 2010 IMPACT TEST SPECIFICATIONS FOR VEHICLE SECURITY BARRIERS
BS 4485-4:1996 Water cooling towers Code of practice for structural design and construction
BS 7777-3:1993 Flat-bottomed, vertical, cylindrical storage tanks for low temperature service Recommendations for the design and construction of prestressed and reinforced concrete tanks and tank foundations, and for the design and installation of tank insulation, tank liners and tank coatings
09/30209209 DC : 0 BS 5911-3 - CONCRETE PIPES AND ANCILLARY CONCRETE PRODUCTS - PART 3: SPECIFICATION FOR UNREINFORCED AND REINFORCED CONCRETE MANHOLES AND SOAKAWAYS (COMPLEMENTARY TO BS EN 1917:2002)
BS 6349-6:1989 Maritime structures Design of inshore moorings and floating structures
BS 5911-100:1988 Precast concrete pipes, fittings and ancillary products Specification for unreinforced and reinforced pipes and fittings with flexible joints
ENA TS 43-4 : ISSUE 2 AMD 1 1993 DESIGN OF FOUNDATIONS FOR STEEL TOWERS FOR OVERHEAD TRANSMISSION LINES AT 132 KV AND HIGHER VOLTAGES
BS 8110-1:1985 Structural use of concrete Code of practice for design and construction
BS 7777-1:1993 Flat-bottomed, vertical, cylindrical storage tanks for low temperature service Guide to the general provisions applying for design, construction, installation and operation
BS 8002:1994 Code of practice for earth retaining structures
BS 5493:1977 Code of practice for protective coating of iron and steel structures against corrosion
BS 8000-2.1:1990 Workmanship on building sites. Code of practice for concrete work Mixing and transporting concrete
PD 7974-3:2003 Application of fire safety engineering principles to the design of buildings Structural response and fire spread beyond the enclosure of origin (Sub-system 3)
BS 8202-1:1987 Coatings for fire protection of building elements Code of practice for the selection and installation of sprayed mineral coatings
BS 8110-3(1985) : 1985 STRUCTURAL USE OF CONCRETE - PART 3: DESIGN CHARTS FOR SINGLY REINFORCED BEAMS, DOUBLY REINFORCED BEAMS AND RECTANGULAR COLUMNS
07/30150912 DC : 0 BS 5975 - CODE OF PRACTICE FOR THE PROCEDURAL CONTROL OF TEMPORARY WORKS AND THE PERMISSIBLE STRESS DESIGN OF FALSEWORK
BS 8208-1:1985 Guide to assessment of suitability of external cavity walls for filling with thermal insulants Existing traditional cavity construction
BS 8200:1985 Code of practice for design of non-loadbearing external vertical enclosures of buildings
09/30201029 DC : DRAFT MAY 2009 BS 6089 - ASSESSMENT OF IN-SITU COMPRESSIVE STRENGTH IN STRUCTURES AND PRECAST CONCRETE COMPONENTS - COMPLEMENTARY GUIDANCE TO THAT GIVEN IN BS EN 13791
BS 5977-2:1983 Lintels Specification for prefabricated lintels
PD 6687-1:2010 Background paper to the National Annexes to BS EN 1992-1 and BS EN 1992-3
BS 8007:1987 CODE OF PRACTICE FOR DESIGN OF CONCRETE STRUCTURES FOR RETAINING AQUEOUS LIQUIDS
BS 8298:1989 Code of practice for design and installation of natural stone cladding and lining
BS 8298:1994 Code of practice for design and installation of natural stone cladding and lining
PD 6686:2006 Guidance on directives, regulations and standards related to prevention of fire and explosion in the process industries
BS 5911-5(2004) : 2004 CONCRETE PIPES AND ANCILLARY CONCRETE PRODUCTS - PART 5: SPECIFICATION FOR PRESTRESSED NON-PRESSURE PIPES AND FITTINGS WITH FLEXIBLE JOINTS
17/30342957 DC : 0 BS 8297 - DESIGN, MANUFACTURE AND INSTALLATION OF ARCHITECTURAL PRECAST CONCRETE CLADDING - CODE OF PRACTICE
BS 5911-110:1992 Precast concrete pipes, fittings and ancillary products Specification for ogee pipes and fittings (including perforated)
BS 5911-200:1989 Precast concrete pipes, fittings and ancillary products Specification for unreinforced and reinforced manholes and soakaways of circular cross section
BS 8006:1995 Code of practice for strengthened/reinforced soils and other fills
BS 8102:1990 Code of practice for protection of structures against water from the ground
BS 5911-120:1989 Precast concrete pipes, fittings and ancillary products Specification for reinforced jacking pipes with flexible joints
PD 6687:2006 Background paper to the UK National Annexes to BS EN 1992-1
BS 8010-3:1993 Code of practice for pipelines Pipelines subsea: design, construction and installation
BS 5911-3(2010) : 2010 CONCRETE PIPES AND ANCILLARY CONCRETE PRODUCTS - PART 3: SPECIFICATION FOR UNREINFORCED AND REINFORCED CONCRETE MANHOLES AND SOAKAWAYS (COMPLEMENTARY TO BS EN 1917:2002)
BS 5975:1996 Code of practice for falsework
BS 5950-4:1994 STRUCTURAL USE OF STEELWORK IN BUILDING - PART 4: CODE OF PRACTICE FOR DESIGN OF COMPOSITE SLABS WITH PROFILED STEEL SHEETING

BS 8500-2:2002 Concrete. Complementary British Standard to BS EN 206-1 Specification for constituent materials and concrete
BS 8007:1987 CODE OF PRACTICE FOR DESIGN OF CONCRETE STRUCTURES FOR RETAINING AQUEOUS LIQUIDS
BS EN 197-1:2011 Cement Composition, specifications and conformity criteria for common cements
BS 8500-1:2002 Concrete. Complementary British Standard to BS EN 206-1 Method of specifying and guidance for the specifier
BS 8666:2005 Scheduling, dimensioning, bending and cutting of steel reinforcement for concrete. Specification
BS 6213(2000) : 2000 SELECTION OF CONSTRUCTION SEALANTS - GUIDE
BS 6089:1981 Guide to assessment of concrete strength in existing structures

View more information
£258.00
Excluding VAT

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.