AGMA 915-1 : A
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
INSPECTION PRACTICES - PART 1: CYLINDRICAL GEARS - TANGENTIAL MEASUREMENTS
01-01-2002
24-11-2020
Foreword
1 Scope
2 References
3 Symbols and corresponding terms
4 Extent of gear inspection
5 Identification of deviation position
6 Measurement of pitch deviations
7 Measurement of profile deviations
8 Measurement of helix deviations
9 Measurement of single flank composite deviations
10 Contact pattern checking
Figures
Tables
Provides a code of practice dealing with tangential measurements on flanks of individual cylindrical involute gears., i.e., with the measurement of pitch, profile, helix and tangential composite characteristics.
| DevelopmentNote |
Supplements AGMA 2015-1. (01/2003) Supersedes AGMA ISO 10064-1. (04/2009) Supersedes AGMA 2000. (12/2009) Supersedes AGMA 2015/915-1. (05/2017)
|
| DocumentType |
Standard
|
| PublisherName |
American Gear Manufacturers Association
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| AGMA 2015/915-1 : A2002 | ACCURACY CLASSIFICATION SYSTEM - TANGENTIAL MEASUREMENT TOLERANCE TABLES FOR CYLINDRICAL GEARS |
| AGMA 2015-1 : A | ACCURACY CLASSIFICATION SYSTEM - TANGENTIAL MEASUREMENTS FOR CYLINDRICAL GEARS |
| AGMA 915-2 : A | INSPECTION PRACTICES - PART 2: CYLINDRICAL GEARS - RADIAL MEASUREMENTS |
| BS ISO 1328-1:2013 | Cylindrical gears. ISO system of flank tolerance classification Definitions and allowable values of deviations relevant to flanks of gear teeth |
| 11/30229116 DC : 0 | BS ISO 1328-1 - CYLINDRICAL GEARS - ISO SYSTEM OF TOLERANCE CLASSIFICATION - PART 1: DEFINITIONS AND ALLOWABLE VALUES OF DEVIATIONS RELEVANT TO CORRESPONDING FLANKS OF GEAR TEETH |
| ISO 1328-1:2013 | Cylindrical gears — ISO system of flank tolerance classification — Part 1: Definitions and allowable values of deviations relevant to flanks of gear teeth |
| AGMA 2015-1 : A | ACCURACY CLASSIFICATION SYSTEM - TANGENTIAL MEASUREMENTS FOR CYLINDRICAL GEARS |
| ISO 701:1998 | International gear notation — Symbols for geometrical data |
| ISO 53:1998 | Cylindrical gears for general and heavy engineering — Standard basic rack tooth profile |
| ISO 54:1996 | Cylindrical gears for general engineering and for heavy engineering — Modules |
| AGMA 915-3 : A1999(R2017) | INSPECTION PRACTICES - GEAR BLANKS, SHAFT CENTER DISTANCE AND PARALLELISM |