AGMA 932 : A
Superseded
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
RATING THE PITTING RESISTANCE AND BENDING STRENGTH OF HYPOID GEARS
Published date
01-01-2005
Publisher
Superseded date
06-11-2023
Superseded by
Sorry this product is not available in your region.
Foreword
1 Scope
2 Normative references
3 Nomenclature
4 Applicability
5 Fundamental rating formulas
6 Geometry factors, I (Z[I]) and J (Y[J])
Annexes
A Geometry factor graphs
B Hypoid gear sample calculations
Presents a method for calculating the pitting resistance and bending strength of hypoid gears using the procedures of ANSI/AGMA 2003-B97.
| DevelopmentNote |
Supplements AGMA 2003. (02/2015)
|
| DocumentType |
Standard
|
| PublisherName |
American Gear Manufacturers Association
|
| Status |
Superseded
|
| SupersededBy |
| ISO 10300-3:2014 | Calculation of load capacity of bevel gears — Part 3: Calculation of tooth root strength |
| BS ISO 10300-2:2014 | Calculation of load capacity of bevel gears Calculation of surface durability (pitting) |
| BS ISO 10300-3:2014 | Calculation of load capacity of bevel gears Calculation of tooth root strength |
| ISO 10300-2:2014 | Calculation of load capacity of bevel gears — Part 2: Calculation of surface durability (pitting) |
| AGMA 2003 : B | RATING THE PITTING RESISTANCE AND BENDING STRENGTH OF GENERATED STRAIGHT BEVEL, ZEROL BEVEL AND SPIRAL BEVEL GEAR TEETH |
| AGMA 2005 : D | DESIGN MANUAL FOR BEVEL GEARS |
Summarise
Sorry this product is not available in your region.