AGMA 935 : A
Superseded
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
RECOMMENDATIONS RELATIVE TO THE EVALUATION OF RADIAL COMPOSITE GEAR DOUBLE FLANK TESTERS
Published date
01-01-2005
Publisher
Superseded date
07-07-2020
Superseded by
Sorry this product is not available in your region.
Foreword
1 Scope
2 References
3 Definition of terms
4 Instrument environment
5 Measurement system condition
6 Artifacts
7 Statistical process control
8 Instrument fitness for use
9 Measurement process (instrument correlation)
Bibliography
Describes qualification procedures for double flank testers that are used for the evaluation of radial composite deviations of gears. Recommendations are included for establishment of a proper environment.
| DevelopmentNote |
Supplements AGMA 2116. (11/2009)
|
| DocumentType |
Standard
|
| PublisherName |
American Gear Manufacturers Association
|
| Status |
Superseded
|
| SupersededBy |
| AGMA 915-2 : A | INSPECTION PRACTICES - PART 2: CYLINDRICAL GEARS - RADIAL MEASUREMENTS |
| AGMA 2116 : A | EVALUATION OF DOUBLE FLANK TESTERS FOR RADIAL COMPOSITE MEASUREMENT OF GEARS |
| AGMA 2015-1 : A | ACCURACY CLASSIFICATION SYSTEM - TANGENTIAL MEASUREMENTS FOR CYLINDRICAL GEARS |
| ISO 18653:2003 | Gears — Evaluation of instruments for the measurement of individual gears |
| AGMA 2015-2 : A | GEAR TOOTH FLANK TOLERANCE CLASSIFICATION SYSTEM - DEFINITIONS AND ALLOWABLE VALUES OF DOUBLE FLANK RADIAL COMPOSITE DEVIATIONS |
| ISO 14253-1:2017 | Geometrical product specifications (GPS) — Inspection by measurement of workpieces and measuring equipment — Part 1: Decision rules for verifying conformity or nonconformity with specifications |
| AGMA 915-2 : A | INSPECTION PRACTICES - PART 2: CYLINDRICAL GEARS - RADIAL MEASUREMENTS |
| AGMA 2116 : A | EVALUATION OF DOUBLE FLANK TESTERS FOR RADIAL COMPOSITE MEASUREMENT OF GEARS |
| AGMA 1012 : 2005 | GEAR NOMENCLATURE, DEFINITIONS OF TERMS WITH SYMBOLS |
| ISO/TR 10064-5:2005 | Code of inspection practice — Part 5: Recommendations relative to evaluation of gear measuring instruments |
Summarise
Sorry this product is not available in your region.