AGMA ISO 23509 : A
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
BEVEL AND HYPOID GEAR GEOMETRY
01-01-2008
25-02-2015
Foreword
1 Scope
2 Normative references
3 Terms, definitions and symbols
4 Design considerations
5 Tooth geometry and cutting considerations
6 Pitch cone parameters
7 Gear dimensions
8 Undercut check
Annexes
Annex A (informative) Structure of ISO formula set for
calculation of geometry data of bevel and hypoid gears
Annex B (informative) Pitch cone parameters
Annex C (informative) Gear dimensions
Annex D (informative) Analysis of forces
Annex E (informative) Machine tool data
Annex F (informative) Sample calculations
Describes the geometry of bevel gears. The term bevel gears is used to mean straight, spiral, zerol bevel and hypoid gear designs.
| DevelopmentNote |
Supersedes AGMA 2005. (02/2015)
|
| DocumentType |
Standard
|
| PublisherName |
American Gear Manufacturers Association
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| Standards | Relationship |
| ISO 23509:2016 | Identical |
| ISO 10300-1:2014 | Calculation of load capacity of bevel gears — Part 1: Introduction and general influence factors |
| ISO 10300-3:2014 | Calculation of load capacity of bevel gears — Part 3: Calculation of tooth root strength |
| ISO 10300-2:2014 | Calculation of load capacity of bevel gears — Part 2: Calculation of surface durability (pitting) |