Customer Support: 131 242

  • There are no items in your cart
We noticed you’re not on the correct regional site. Switch to our AMERICAS site for the best experience.
Dismiss alert

ANSI/AWWA C903:2016

Superseded

Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by

POLYETHYLENE-ALUMINUM-POLYETHYLENE (PEALPE) COMPOSITE PRESSURE PIPE, 12 MM (1/2 IN.) THROUGH 51 MM (2 IN.), FOR WATER SERVICE

Available format(s)

Hardcopy , PDF

Superseded date

03-09-2024

Language(s)

English

Published date

01-12-2016

Foreword
 I Introduction
 II Special Issues
 III Use of This Standard
 IV Major Revisions
 V Comments
Standard
 1 General
 2 References
 3 Definitions
 4 Requirements
 5 Verification
 6 Delivery
Appendix
A Bibliography for Additional
  Information

Specifies the requirements for composite polyethylene- aluminum-polyethylene pipe (hereinafter referred to as PE-AL-PE) in metric nominal inside diameter (ID) sizes 12 mm (1/2 in.) through 51 mm (2 in.).

DocumentType
Standard
ISBN
978-1-62576-188-0
Pages
32
PublisherName
American Water Works Association
Status
Superseded
SupersededBy
Supersedes

ICC IRC CODE AND COMMENTARY VOLUME 2 : 2015 IRC® Code and Commentary, Volume 2

ANSI H35.1/H35.1M : 2017 ALLOY AND TEMPER DESIGNATION SYSTEMS FOR ALUMINUM
NSF 61 : 2016 DRINKING WATER SYSTEM COMPONENTS - HEALTH EFFECTS
PPI TR 3 : 2017 POLICIES AND PROCEDURES FOR DEVELOPING HYDROSTATIC DESIGN BASIS (HDB), HYDROSTATIC DESIGN STRESSES (HDS), PRESSURE DESIGN BASIS (PDB), STRENGTH DESIGN BASIS (SDB), MINIMUM REQUIRED STRENGTH (MRS) RATINGS, AND CATEGORIZED REQUIRED STRENGTH (CRS) FOR THERMOPLASTIC PIPING MATERIALS OR PIPE
ASTM F 1282 : 2017 : REDLINE Standard Specification for Polyethylene/Aluminum/Polyethylene (PE-AL-PE) Composite Pressure Pipe
PPI TR 4 : 2017 HDB/HDS/SDB/PDB/MRS LISTED MATERIALS - PPI LISTING OF HYDROSTATIC DESIGN BASIS (HDB), HYDROSTATIC DESIGN STRESS (HDS), STRENGTH DESIGN BASIS (SDB), PRESSURE DESIGN BASIS (PDB) AND MINIMUM REQUIRED STRENGTH (MRS) RATINGS FOR THERMOPLASTIC PIPING MATERIALS OR PIPE
ASTM B 209 : 2014 : REDLINE Standard Specification for Aluminum and Aluminum-Alloy Sheet and Plate
ASTM D 2122 : 2016 : REDLINE Standard Test Method for Determining Dimensions of Thermoplastic Pipe and Fittings
ASTM D 3350 : 2014 : REDLINE Standard Specification for Polyethylene Plastics Pipe and Fittings Materials
ASTM E 8/E8M : 2016-09 TEST METHODS FOR TENSION TESTING OF METALLIC MATERIALS

$232.44
Including GST where applicable

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.

Need help?
Call us on 131 242, then click here to start a Screen Sharing session
so we can help right away! Learn more