AS 1646.4-2005
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Elastomeric seals for waterworks purposes Material requirements for pipe joint seals used in water and wastewater applications - Thermoplastic elastomers and vulcanizates
Hardcopy , PDF 1 User , PDF 3 Users , PDF 5 Users , PDF 9 Users
01-01-2005
23-05-2024
Specifies requirements for thermoplastic elastomers and vulcanizates for moulding seals used in joints of thermoplastic piping systems for non-pressure waste discharge (intermittent flow up to 95 degrees Celsius) inside buildings; thermoplastic piping systems for non-pressure underground drainage and sewerage (continuous flow up to 45 degrees Celsius and intermittent flow up to 95 degrees C); and thermoplastic rainwater piping systems.
| Committee |
WS-010
|
| DocumentType |
Standard
|
| ISBN |
0 7337 6809 1
|
| Pages |
11
|
| PublisherName |
Standards Australia
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes | |
| UnderRevision |
This Standard specifies requirements for thermoplastic elastomers and vulcanizates for moulding seals used in joints of -a) thermoplastic piping systems for non-pressure waste discharge (intermittent flow up to 95°C) inside buildings;b) thermoplastic piping systems for non-pressure underground drainage and sewerage (continuous flow up to 45°C and intermittent flow up to 95°C); andc) thermoplastic rainwater piping systems.General requirements for finished joint seals are also specified. Any additional requirements called for by the particular application are specified in relevant product Standards taking into account that the performance of pipe joints is a function of the seal material properties, seal geometry and pipe joint design. Note:Means for demonstrating compliance with this Standard are given in AppendixA.
First published as AS 1646.4-2005.
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.