AS 3894.1-1991
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Site testing of protective coatings Non-conductive coatings - Continuity testing - High voltage (brush) method
Hardcopy , PDF 1 User , PDF 3 Users , PDF 5 Users , PDF 9 Users
English
01-01-1991
30-06-2017
Specifies a method of test for determining the presence of pinholes, cracks, holidays, and other discontinuities that penetrate to the substrate in non-conductive protective coatings of at least 150 micrometres applied to a conductive substrate, using the high voltage or brush method.
| Committee |
CH-003
|
| DocumentType |
Standard
|
| ISBN |
0 7262 6867 4
|
| Pages |
14
|
| PublisherName |
Standards Australia
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
This Standard sets out a method of test for determining the presence of pinholes, holidays, cracks and other discontinuities which penetrate to the substrate, in a nonconductive, protective coating of at least 150 mm thickness (see Note) on a conductive substrate, using the high voltage or 'brush' method.NOTE: Where coatings are less than 150 mm thick, an alternative method such as the low voltage wet sponge method should be used. This Standard is applicable to site testing of coated metal items of equipment or structures which may be subjected to long-term burial or immersion, such as structural steel, pipelines, storage vessels, bridges and mobile/transportable containers. The method is confined to testing instruments which can provide a minimum voltage of 500 V. The Standard is not intended to apply to coating types incorporating components that conduct an electric current, such as zinc dust and aluminium flakes. The voltages recommended in this Standard are intended to be applied under conditions of normal atmospheric pressure and temperature.
First published as AS 3894.1-1991
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.