AS 4100-1998
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Steel structures (Reconfirmed 2016)
Hardcopy , PDF 1 User , PDF 3 Users , PDF 5 Users , PDF 9 Users
05-06-1998
01-10-2026
This Standard sets out minimum requirements for the design, fabrication, erection, and modification of steelwork in structures in accordance with the limit states design method. This Standard applies to buildings, structures and cranes constructed of steel.
| Committee |
BD-001
|
| DocumentType |
Standard
|
| ISBN |
0 7337 1981 3
|
| Pages |
209
|
| ProductNote |
Reconfirmed 03/06/2016.This standard has been reconfirmed in Australia in 2016 and remains current in New Zealand. Reconfirmation Notice 03/06/2016
|
| PublisherName |
Standards Australia
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes | |
| UnderRevision |
This Standard sets out minimum requirements for the design, fabrication, erection, and modification of steelwork in structures in accordance with the limit states design method. This Standard applies to buildings, structures and cranes constructed of steel.This Standard is intended to apply also to roadway, railway, and pedestrian bridges. However, the requirements given in this Standard may not always be sufficient for bridge applications. In these circumstances, the specifications of the relevant Authority shall be used.This Standard does not apply to the following structures and materials:(a) Steel elements less than 3 mm thick, with the exception of sections complying with AS 1163 and packers.(b) Steel members for which the value of the yield stress used in design (fy) exceeds 450 MPa.(c) Cold-formed members, other than those complying with AS 1163, which shall be designed in accordance with AS/NZS 4600.(d) Composite steel-concrete members, which shall be designed in accordance with AS 2327.NOTE: The general principles of design, fabrication, erection, and modification embodied in this Standard may be applied to steel-framed structures or members not specifically mentioned herein.
Originated in part as SAA INT 351-1956.
Previous edition AS 4100-1990.
Second edition 1998.
Reissued incorporating Amendment No. 1 (February 2012).
A newer version of this standard is available.
View Current Edition
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.