Customer Support: 131 242

i2i Intertek.com
  • Shopping Cart
    There are no items in your cart
We noticed you’re not on the correct regional site. Switch to our AMERICAS site for the best experience.
Go to AMERICAS site
Dismiss alert
Please enter a keyword to search
Advanced search
Home
Publishers
AS
AS 4180.1-1994

AS 4180.1-1994

Superseded

Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by

Add to Watchlist

Drift loss from cooling towers - Laboratory measurement - Chloride balance method

Available format(s)

Hardcopy , PDF 1 User , PDF 3 Users , PDF 5 Users , PDF 9 Users

Language(s)

English

Published date

01-01-1994

Publisher

Standards Australia

Superseded date

17-05-2018

Superseded by

AS 4180.1-2008

Add to Watchlist
Preview
$63.00
Including GST where applicable

1 - AS 4180.1:1994 DRIFT LOSS FROM COOLING TOWERS - LABORATORY MEASUREMENT - CHLORIDE BALANCE METHOD
4 - PREFACE
5 - CONTENTS
6 - FOREWORD
7 - 1 SCOPE
7 - 2 APPLICATION
7 - 3 REFERENCED DOCUMENTS
7 - 4 DEFINITIONS
7 - 4.1 Circulating water temperature
7 - 4.2 Clean
7 - 4.3 Cooling tower
7 - 4.4 Drift
8 - 4.5 Drift loss mass flow rate
8 - 4.6 Dry bulb temperature
8 - 4.7 Effective wet bulb depression
8 - 4.8 Water mass flow rate
8 - 4.9 Wet bulb depression
8 - 4.10 Wet bulb temperature
8 - 5 GENERAL REQUIREMENTS FOR EQUIPMENT TESTED
8 - 5.1 General
8 - 5.2 Device under test
8 - 5.3 Water leaks
8 - 6 REQUIRED TEST CONDITIONS
8 - 6.1 General
9 - 6.2 Flow rates
9 - 6.3 Wind velocity
9 - 6.4 Rain
9 - 6.5 Test temperatures
9 - 6.6 Water samples
9 - 7 SODIUM CHLORIDE REQUIREMENTS
9 - 7.1 General
9 - 7.2 Sodium chloride mass
9 - 7.3 Accuracy
9 - 7.4 Sodium chloride solution
9 - 8 CHLORIDE ION CONCENTRATION MEASUREMENT
9 - 8.1 Samples
9 - 8.2 Measurement
10 - 9 TEST PROCEDURE
11 - 10 CALCULATIONS
11 - 10.1 Circulating water
11 - 10.2 Drift measurement time
11 - 10.3 Mass of sodium chloride
11 - 10.4 Mean effective wet bulb
11 - 10.5 Evaporation ratio
11 - 10.6 Drift loss
11 - 10.7 Percentage drift loss
12 - 11 TEST REPORT
13 - APPENDIX A - NOMENCLATURE
14 - APPENDIX B - SAMPLE CALCULATIONS
14 - B1 GENERAL
14 - B2 INITIAL MEASUREMENTS
14 - B3 MASS OF SODIUM CHLORIDE
14 - B4 MAKE-UP WATER TIME
14 - B5 DRIFT TIME
14 - B6 SAMPLE READINGS
15 - B7 WATER MASS
15 - B8 CHECK DRIFT TIME
15 - B9 CHECK SALT MASS
15 - B10 EVAPORATION RATIO
16 - B11 DRIFT LOSS RATE
16 - B12 PERCENTAGE DRIFT LOSS
17 - APPENDIX C - SUGGESTED EQUIPMENT

Sets out the requirements necessary to obtain measurements of drift of circulatory water into the atmosphere from a cooling tower, by a chloride ion mass balance on the water circuit, under laboratory conditions.

Committee
ME-062
DocumentType
Standard
ISBN
0 7262 8795 4
Pages
11
PublisherName
Standards Australia
Status
Superseded
SupersededBy
Supersedes
UnderRevision

This Standard sets out the requirements necessary to obtain measurements of drift of circulating water into the atmosphere, by a chloride ion mass balance on the water circuit, under laboratory conditions.

First published as AS 4180.1-1994.

AS 2360.1.4-1993 Measurement of fluid flow in closed conduits Pressure differential methods - Measurement using orifice plates, nozzles or Venturi tubes - Guide to the effect of departure from the conditions specified in Pt 1.1
AS 2360.1.3-1993 Measurement of fluid flow in closed conduits Pressure differential methods - Measurement using orifice plates, nozzles or Venturi tubes - Guide to the use of methods specified in Parts 1.1 and 1.2
AS 2360.1.2-1993 Measurement of fluid flow in closed conduits Pressure differential methods - Measurement using orifice plates or nozzles - Conduits with diameters less than 50 mm
AS 2031.1-1986 Selection of containers and preservation of water samples for chemical and microbiological analysis - Chemical
AS 2093-1977 Salt for use in the manufacture of dairy products
AS 2360.1.1-1993 Measurement of fluid flow in closed conduits Pressure differential methods - Measurement using orifice plates, nozzles or Venturi tubes - Conduits with diameters from 50 mm to 1200 mm
AS 3666-1989 Air-handling and water systems of buildings - Microbial control

AS/NZS 3666.1:2002 Air-handling and water systems of buildings - Microbial control Design, installation and commissioning
SAA/SNZ HB32:1995 Control of microbial growth in air-handling and water systems in buildings (Reconfirmed 2016)
AS/NZS 3666.1:1995 Air-handling and water systems of buildings - Microbial control Design, installation and commissioning

Summarise
ChatGPT Perplexity
$63.00
Including GST where applicable
AUD
CAD
CHF
CNY
DKK
EUR
GBP
HKD
IDR
INR
JPY
KRW
MXN
NOK
NZD
SEK
SGD
USD
ZAR
Hardcopy - English
PDF 1 User - English
PDF 3 Users - English
PDF 5 Users - English
PDF 9 Users - English
01
02
03
04
05
06
07
08
09
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100