AS 4200.2:2017
Current
The latest, up-to-date edition.
Pliable building membranes and underlays Installation
Hardcopy , PDF 1 User , PDF 3 Users , PDF 5 Users , PDF 9 Users
25-06-2021
Sets out requirements for the installation of pliable building membranes (also known as ‘sarking’ or ‘underlay’), when used either independently or as a facing to other materials, such as insulation materials, for water control, thermal control, vapour control or air control, or a combination of these control functions.
| Committee |
BD-058
|
| DevelopmentNote |
New PDF incorporating Amendment 2.
|
| DocumentType |
Standard
|
| ISBN |
978-1-76035-675-0
|
| Pages |
36
|
| PublisherName |
Standards Australia
|
| Status |
Current
|
| Supersedes | |
| UnderRevision |
This Standard sets out requirements for the installation of pliable building membranes (also known as ‘sarking’ or ‘underlay’), when used either independently or as a facing to other materials, such as insulation materials, for any one or more of the following control functions:(a) Water control.(b) Thermal control.(c) Vapour control.(d) Air control.This Standard does not cover requirements for materials used in the following applications:(i) Air-handling ducts and building services.(ii) Under concrete slabs on-ground.(iii) Waterproofing above flat concrete roofs.NOTES: 1 The installation of foil-faced building blanket is covered in AS 3999, except for metal sheet roofing and walls, which are covered in Section 3 of this Standard.2 Where regulations require special attention in bushfire prone areas, it may be necessary for a pliable building membrane to comply with AS 3959.3 This Standard includes advice on work health and safety (WHS), and electrical safety (see Appendix A); however, the user of this Standard needs to refer to relevant federal, state and territory regulations and determine legal requirements as applicable.
Originated in Australia as part of AS CA22-1965.
Previous edition AS/NZS 4200.2:1994.
Third edition revised and designated AS 4200.2:2017.
Reissued incorporating Amendment No 1 (June 2018).
Reissued incorporating Amendment No 2 (June 2021).
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.