AS/NZS 3123:1994
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Approval and test specification - Plugs, socket-outlets and couplers for general industrial application
Hardcopy , PDF 1 User , PDF 3 Users , PDF 5 Users , PDF 9 Users
16-05-1994
29-05-2024
Specifies essential safety requirements for industrial plugs and socket-outlets for approval and test purposes. In Australia, it is to be read in conjunction with AS 3100. In New Zealand, it is to be read in conjunction with NZS 6200.
| Committee |
EL-004
|
| DocumentType |
Standard
|
| ISBN |
0 7262 8855 1
|
| Pages |
57
|
| PublisherName |
Standards Australia
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
This Specification applies to plugs and socket-outlets, cable couplers and appliance couplers for operation at 50 Hz, with a rated voltage not exceeding 660 V and a rated current not exceeding 315 A, primarily intended for general industrial use, either indoors or outdoors.NOTES:This Specification applies to plugs and socket-outlets, cable couplers and appliance couplers (referred to in this specification as 'accessories') for use when the ambient temperature does not normally exceed 40C.The use of these accessories in building sites and in agricultural, commercial and domestic situations is not precluded.Appliance inlets incorporated in or fixed to electrical equipment are within the scope of this specification.This Specification does not apply to accessories which comply with AS 3109.1 and AS/NZS 3112 and which are primarily intended for domestic and similar general purposes, nor to accessories which comply with AS 2380 and are intended for explosive atmospheres.The configurations shown in this Specification depict standardized Australian industrial plugs, socket-outlets, cable couplers and appliance couplers for operation at 50 Hz.This Specification may be applied to configurations and contact types other than those depicted herein (including those to IEC 309), providing all appropriate (to that type) requirements of this Specification are complied with.
First published in Australia as AS C317-1958.
Revised and redesignated AS 3123-1987.
Jointly revised and designated as Joint Standard AS/NZS 3123:1994.
A newer version of this standard is available.
View Current Edition
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.