AS/NZS 3661.1:1993
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Slip resistance of pedestrian surfaces - Requirements
Hardcopy , PDF 1 User , PDF 3 Users , PDF 5 Users , PDF 9 Users
English
01-01-1993
23-06-2021
1 SCOPE2 APPLICATION3 REFERENCED DOCUMENTS4 GENERAL5 FRICTION REQUIREMENTS OF SURFACESAPPENDICESA - METHOD FOR THE MEASUREMENT OF THE COEFFICIENT OF FRICTION OF WET SURFACESB - METHOD FOR THE MEASUREMENT OF THE COEFFICIENT OF FRICTION OF DRY SURFACES
Specifies requirements and test methods for the measurement of the slip resistance of both wet and dry pedestrian surfaces.
| Committee |
BD-094
|
| DocumentType |
Standard
|
| ISBN |
0 7262 8386 X
|
| Pages |
14
|
| PublisherName |
Standards Australia
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
This Standard specifies the minimum coefficient of friction values for pedestrian surfaces when measured in accordance with the test methods set out in Appendices A and B. These test methods enable characteristics of surface materials to be determined in either a wet or dry condition, and are appropriate for measurements to be undertaken either in the laboratory under conditions in which the surface materials are intended to be installed, or in situ after installation.Other test methods can be used to meet the compliance requirements specified herein, for example test procedures based on force plates (see Footnote, Clause 2).This Standard does not cover grating, and may not cover some resilient surfaces.NOTE: Part 2 of this Standard, in course of preparation, will provide information on the reduction of slip hazards where they relate to specific situations.
First published as Joint Standard AS/NZS 3661.1:1993.