ASTM E 576 : 2014 : R2020
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Test Method for Frost/Dew Point of Sealed Insulating Glass Units in the Vertical Position
English
01-05-2020
04-05-2020
| Committee |
E 06
|
| DocumentType |
Test Method
|
| Pages |
10
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1This test method describes a field or laboratory procedure for determining the frost/dew point within the air space(s) of sealed insulating glass units and establishes the criteria for determining whether that point is below or above a given or specified temperature.
1.2This test method also describes the apparatus to be used for these determinations.
1.3The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see 9.1.3 and 9.3.8.
1.5This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
| ASTM E 3223/E3223M : 2020 | Standard Guide for Specifying and Testing Field-Constructed Exterior Building Wall System Mockups in New Construction |
| ASTM E 2813 : 2026 | Standard Practice for Building Enclosure Commissioning |
| ASTM C 1036 : 2025 | Standard Specification for Flat Glass |
| ASTM C 1036 : 2021 | Standard Specification for Flat Glass |
| ASTM C 1036 : 2016 | Standard Specification for Flat Glass |
| ASTM E 77 : 2014 : EDT 1 | Standard Test Method for Inspection and Verification of Thermometers |
| ASTM E 631 : 2015 : R2024 | Standard Terminology of Building Constructions |
| ASTM E 631 : 2015 | Standard Terminology of Building Constructions |
| ASTM E 77 : 1998 | Standard Test Method for Inspection and Verification of Thermometers |
| ASTM E 77 : 2014 : R2021 | Standard Test Method for Inspection and Verification of Thermometers |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.