ATS 4747.5-2008
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Meters for non-urban water supply Installation and commissioning of closed conduit meters fully charged
Hardcopy , PDF 1 User , PDF 3 Users , PDF 5 Users , PDF 9 Users
English
30-06-2008
30-06-2017
Sets out requirements for installation of meters complying with ATS 4747.2 for use in non-urban applications in closed conduit applications.
| Committee |
CE-024
|
| DocumentType |
Technical Specification
|
| ISBN |
0 7337 8757 6
|
| Pages |
21
|
| PublisherName |
Standards Australia
|
| Status |
Superseded
|
| SupersededBy | |
| UnderRevision |
This Australian Technical Specification sets out requirements for installation of meters complying with ATS 4747.2 for use in non-urban applications in closed conduit applications.Two types of meter installations are covered in this Australian Technical Specification, as follows:(a) Meters whose calibration is not affected by the installation, provided the installation is in accordance with the installation conditions specified in the manufacturer’s instructions and/or conditions of pattern approval.(b) Meters that are installed in accordance with an Australian Technical Specification, which need to be - (i) calibrated after installation in order to conform with the accuracy requirements; and(ii) endorsed by the authority having jurisdiction before they can be used.In this Australian Technical Specification a meter installation is considered to include - (A) meter and display unit; and(B) upstream and downstream pipe work or emplacement that may have a material effect on the meter unit.This Australian Technical Specification applies to meters that operate under the following conditions:1 Closed conduit under full flow.2 Pressure ranges minimum 0.03 MPa to a value specified by the manufacturer. As a minimum, insertion or clamp-on meters will have the same working pressure range as the pipes they are designed to operate in.3 Working water temperature range of 0.1°C to 30°C. The maximum admissible temperature is 50°C, which is the limiting condition for the meter.4 Ambient air temperature range of (5°C to 55°C.5 Ambient humidity range of 0% to 100% except for the remote indicating devices where the range is 0% to 93%.
First published as ATS 4747.5-2008.
| ATS 4747.2-2008 | Meters for non-urban water supply Specification for closed conduit meters fully charged |
| ATS 4747.1-2008 | Meters for non-urban water supply Glossary of terms |
| AS 3778.1-2001 | Measurement of water flow in open channels Vocabulary and symbols |
| ATS 4747.8-2010 | Meters for non-urban water supply In-service compliance for non-urban water meters |
| ATS 4747.2-2008 | Meters for non-urban water supply Specification for closed conduit meters fully charged |
| ATS 4747.3-2008 | Meters for non-urban water supply Specifications for open channel meters |
Access your standards online with a subscription
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.
Important note : All end users must be registered with an Account prior to user licenses being assigned.