BIS IS 1285 : 2002(R2012)
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
WROUGHT ALUMINIUM AND ALUMINIUM ALLOYS - EXTRUDED ROUND TUBE AND HOLLOW SECTIONS FOR GENERAL ENGINEERING PURPOSES - SPECIFICATION
12-01-2013
15-07-2023
FOREWORD
1 SCOPE
2 REFERENCES
3 TERMINOLOGY
4 SUPPLY OF MATERIAL
5 FREEDOM FROM DEFECTS
6 CONDITIONS OF SUPPLY
7 DIMENSIONS AND TOLERANCES
8 CHEMICAL COMPOSITION
9 MECHANICAL PROPERTIES
10 SELECTION OF TEST SAMPLES
11 RETEST
12 MARKING
ANNEX A - CHARACTERISTICS AND TYPICAL USES OF ALLOYS
ANNEX B - COMPARISON OF NEW IS TEMPERS WITH THE OLD TEMPERS
ANNEX C - COMMITTEE COMPOSITION
Describes the requirements for wrought aluminium and aluminium alloy extruded round tubes and hollow sections for general engineering purposes.
| Committee |
MTD 7
|
| DocumentType |
Standard
|
| PublisherName |
Bureau of Indian Standards
|
| Status |
Superseded
|
| SupersededBy |
| BIS IS 10558 : 2013 | ALUMINIUM SHORE GANGWAYS - SPECIFICATION |
| BIS IS 8442 : 2008 | STAND POST TYPE WATER AND FOAM MONITOR FOR FIRE FIGHTING - SPECIFICATION |
| IS 204 : Part 2 : 1992(R2022) | Tower Bolts - Specification Part-2 Non-Ferrous Metals |
| BIS IS 2673 : 2002 | DIMENSIONS FOR WROUGHT ALUMINIUM AND ALUMINIUM ALLOYS EXTRUDED ROUND TUBE - SPECIFICATION |
| BIS IS 5047-2 : 1979(R2001) | GLOSSARY OF TERMS RELATING TO ALUMINIUM AND ALUMINIUM ALLOYS - PART 2: PLANT AND OPERATIONS, THERMAL TREATMENT, CONTROL AND TESTING, FINISHING |
| BIS IS 10259 : 1982(R2014) | GENERAL CONDITIONS FOR DELIVERY AND INSPECTION OF ALUMINIUM AND ALUMINIUM ALLOY PRODUCTS |
| BIS IS 6051 : 1970(R2014) | CODE FOR DESIGNATION OF ALUMINIUM AND ITS ALLOYS |
| BIS IS 1608 : 2005 | METALLIC MATERIALS - TENSILE TESTING AT AMBIENT TEMPERATURE |
| BIS IS 5052 : 1993(R2003) | ALUMINIUM AND ITS ALLOYS - TEMPER DESIGNATIONS |
| BIS IS 2673 : 2002 | DIMENSIONS FOR WROUGHT ALUMINIUM AND ALUMINIUM ALLOYS EXTRUDED ROUND TUBE - SPECIFICATION |
| BIS IS 5047-1 : 1986(R2001) | GLOSSARY OF TERMS RELATING TO ALUMINIUM AND ALUMINIUM ALLOYS - PART 1: UNWROUGHT AND WROUGHT METALS |
| BIS IS 6477 : 1983(R2016) | DIMENSIONS FOR WROUGHT ALUMINIUM AND ALUMINIUM ALLOYS, EXTRUDED HOLLOW SECTIONS |
| BIS IS 504 : 1963(R2010) | METHODS OF CHEMICAL ANALYSIS OF ALUMINIUM AND ITS ALLOYS |