BIS IS 4000 : 1992(R2003)
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
HIGH STRENGTH BOLTS IN STEEL STRUCTURES - CODE OF PRACTICE
12-01-2013
02-07-2021
FOREWORD
1 SCOPE
2 REFERENCES
3 TERMINOLOGY AND SYMBOLS
4 BOLT, NUTS AND WASHERS
5 DESIGN
6 FABRICATION
7 ASSEMBLY
8 INSPECTION
ANNEX A - LIST OF INDIAN STANDARDS REFERRED
ANNEX B - STANDARD TEST FOR EVALUATION OF SLIP FACTOR
ANNEX C - RECOMMENDED SLIP FACTORS
ANNEX D - INSPECTION OF BOLT TENSION USING A
TORQUE WRENCH
Describes the requirements for the design, fabrication, assembly and inspection in all types of steel structures, of structural joints using high strength bolts.
| Committee |
CED 7
|
| DocumentType |
Standard
|
| PublisherName |
Bureau of Indian Standards
|
| Status |
Superseded
|
| SupersededBy |
| BIS IS 802-1-2 : 1992(R2003) | USE OF STRUCTURAL STEEL IN OVERHEAD TRANSMISSION LINE TOWERS - CODE OF PRACTICE - PART 1: MATERIAL, LOADS AND PERMISSIBLE STRESSES - SECTION 2: PERMISSIBLE STRESSES |
| BIS IS 800 : 2007 AMD 1 2012 | GENERAL CONSTRUCTION IN STEEL - CODE OF PRACTICE |
| BIS IS 3757 : 1985(R2003) | SPECIFICATION FOR HIGH STRENGTH STRUCTURAL BOLTS |
| BIS IS 6649 : 1985(R2010) | SPECIFICATION FOR HARDENED AND TEMPERED WASHERS FOR HIGH STRENGTH STRUCTURAL BOLTS AND NUTS |
| BIS IS 6623 : 2004 | HIGH STRENGTH STRUCTURAL NUTS - SPECIFICATION |
| BIS IS 8537 : 1977(R1996) | NOMENCLATURE AND TERMINOLOGY OF FASTENERS |