BS 1640-3:1968
Current
The latest, up-to-date edition.
Specification for steel butt-welding pipe fittings for the petroleum industry Wrought carbon and ferritic alloy steel fittings. Metric units
Hardcopy , PDF
English
22-03-1968
Co-operating organizations
Foreword
Specification
1 General
1.1 Scope
1.2 Size and size identification
1.3 Pressure ratings
1.4 Materials
1.5 Manufacture
1.6 Heat treatment
2 Dimensions and tolerances
2.1 Dimensions
2.2 Tolerances
3 Workmanship, marking, inspection, testing and
certification
3.1 Workmanship and finish
3.2 Marking
3.3 Inspection
3.4 Test facilities
3.5 Prototype bursting tests
3.6 Radiographic examination of fittings fabricated by
fusion welding
3.7 Radiographic technique and acceptance limits
3.8 Impact testing
3.9 Hydrostatic testing
3.10 Certificate
Appendix
A Information to be supplied by the purchaser
Tables
1 Materials and material identification symbols
2 Tolerances
3 Outside diameter and nominal wall thickness of
steel pipe
4 Dimensions of elbows and return bends
5 Dimensions of 90 deg long radius tangent elbows
6 Dimensions of equal tees
7 Dimensions of reducing tees
8 Dimensions of reducers (concentric and eccentric)
9 Dimensions of caps
10 Dimensions of lap-joint stub-ends
Figures
1 Welding end for wall thicknesses from 4.8 mm to
22 mm inclusive
2 Welding end for wall thicknesses greater than
22 mm
3 Typical examples of off-square tolerance 'X'
checked against reference planes
Dimensions and tolerances, materials, methods of manufacture, pressure/temperature ratings, marking, inspection, tests for seamless and fabricated fittings: 45° long radius elbows, 90° long and short radius elbows, 90° long radius tangent elbows, long and short radius return bends, equal and reducing tees, concentric and eccentric reducers, caps and lap-joint stub ends, of sizes 19 mm to 609.5 mm. Welding-neck flanges not included.
| Committee |
ISE/110
|
| DevelopmentNote |
Reviewed and confirmed by BSI, January 2008. (12/2007)
|
| DocumentType |
Standard
|
| Pages |
22
|
| PublisherName |
British Standards Institution
|
| Status |
Current
|
| SupersededBy |
Part 3 of this British Standard specifies requirements for wrought seamless and fabricated carbon and ferritic alloy steel butt-welding pipe fittings for use in the petroleum industry, and is in metric units.
The following types of fittings are provided for:
45° long radius elbows;
90° long and short radius elbows;
90° long radius tangent elbows;
long and short radius return bends;
equal and reducing tees;
concentric and eccentric reducers;
caps;
lap-joint stub ends.
Welding-neck flanges are not included. They are included in BS 15601) and BS 32932).
Attention is drawn to Appendix A, which lists information to be supplied by the purchaser.
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.