BS 2000-49(2000) : 2000
Superseded
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
METHODS OF TEST FOR PETROLEUM AND ITS PRODUCTS - BITUMEN AND BITUMINOUS BINDERS - DETERMINATION OF NEEDLE PENETRATION
Published date
12-01-2013
Superseded date
31-05-2007
Superseded by
Sorry this product is not available in your region.
Foreword
1 Scope
2 Normative references
3 Definitions
4 Principle
5 Apparatus
6 Sampling
7 Procedure
8 Expression of results
9 Precision
10 Test report
Figures
Annex A (normative) Characteristics of thermometers
Annex B (informative) Bibliography
Defines a method to determine the consistency of bitumen and bituminous binders.
| Committee |
PTI/13
|
| DevelopmentNote |
Supersedes BS 2000-49(1993) (10/2001) Reviewed and confirmed by BSI, August, 2004. (11/2004)
|
| DocumentType |
Standard
|
| PublisherName |
Energy Institute (formerly Institute of Petroleum - IP)
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| 10/30213884 DC : 0 | BS 594987 - ASPHALT FOR ROADS AND OTHER PAVED AREAS - SPECIFICATION FOR TRANSPORT, LAYING AND COMPACTION AND TYPE TESTING PROTOCOLS |
| DEFSTAN 68-138/2(1997) : 1997 | BITUMEN, GRADES 1, 2 AND 3 |
| BS 1858:2002 | Electric cables. Accessories. Bitumen-based filling compounds |
| BS 598-107:2004 | Sampling and examination of bituminous mixtures for roads and other paved areas Method of test for the determination of the composition of design surface course rolled asphalt |
| BS 4164:2002 | Specification for coal-tar-based hot-applied coating materials for protecting iron and steel, including a suitable primer |
| BS 594987:2007 | Asphalt for roads and other paved areas - Specification for transport, laying and compaction and type testing protocols. |
| EN 1425:2012 | Bitumen and bituminous binders - Characterization of perceptible properties |
| PREN 12597 : DRAFT 2012 | BITUMEN AND BITUMINOUS BINDERS - TERMINOLOGY |
| ISO 1829:1975 | Selection of tolerance zones for general purposes |
| EN 1427:2015 | Bitumen and bituminous binders - Determination of the softening point - Ring and Ball method |
| ISO 1101:2017 | Geometrical product specifications (GPS) — Geometrical tolerancing — Tolerances of form, orientation, location and run-out |
| EN 10088-3:2014 | Stainless steels - Part 3: Technical delivery conditions for semi-finished products, bars, rods, wire, sections and bright products of corrosion resisting steels for general purposes |
| ISO 1302:2002 | Geometrical Product Specifications (GPS) — Indication of surface texture in technical product documentation |
| EN 58:2012 | Bitumen and bituminous binders - Sampling bituminous binders |
| ISO 286-1:2010 | Geometrical product specifications (GPS) — ISO code system for tolerances on linear sizes — Part 1: Basis of tolerances, deviations and fits |
| ISO 6508:1986 | Metallic materials — Hardness test — Rockwell test (scales A - B - C - D - E - F - G - H - K) |
| EN 12594:2014 | Bitumen and bituminous binders - Preparation of test samples |
Summarise
Sorry this product is not available in your region.