BS 3382-1&2(1961) : 1961
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
SPECIFICATION FOR ELECTROPLATED COATINGS ON THREADED COMPONENTS - CADMIUM ON STEEL COMPONENTS - ZINC ON STEEL COMPONENTS
Hardcopy , PDF
English
01-01-1961
31-07-2008
Co-operating organizations
Foreword
Introductory notes
Specification
1 Scope
2 Definitions
3 Inspection
4 Screw thread dimensions
Part 1. Cadmium plating (bright or dull) on steel
components
5 Resistance to corrosion
6 Purity
7 Adhesion
8 Porosity
9 Reduction of hydrogen embrittlement
10 Finish and appearance of plated surfaces
11 Plating thickness
12 Passivation
Part 2. Zinc plating (bright or dull) for steel
components
13 Resistance to corrosion
14 Purity
15 Reduction of hydrogen embrittlement
16 Finish and appearance of plated surfaces
17 Plating thickness
18 Passivation
Appendices
A Passivation treatment
B 'Strip and weigh' method for the determination of
group and sample average plating thicknesses
C Determination of the thickness of cadmium plating
by the Clarke 'time of gassing' test
D Notes on surface areas of bolts screws and nuts
E Examples of calculations of deposit thicknesses on
plated threaded shanks
Tables
1 Plating thickness
1A Plating thickness (millimetre dimensions)
2 Screws and bolts - B.S.W. and B.S.F. threads
3 Screws and bolts - UNC and UNF threads
4 Screws and bolts - B.A. threads
5 Screws and bolts - B.S.C. and B.S.P. threads
7 Nuts - B.S.W. and B.S.F. threads
8 Nuts - B.A. threads
9 Nuts - UNC and UNF threads
Figures
1 Probable frequency distribution of thickness in a
barrel load
2 Curve of determination of average thickness of
cadmium coatings
3 Constituent surface areas of a screw or bolt
Describes cadmium and zinc plating thicknesses, sampling and other inspection procedures, and methods of thickness determination for components having threads of basic major diameters from 0.060 in to 3/4 in inclusive, specified in the following, BS 84 Parallel screw threads of Whitworth form, BS 93 British Association screw threads, BS 811 Cycle threads, BS 1580 Unified screw threads, BS 2779 Fastening threads of BSP sizes, BS 3643 ISO metric screw threads. Including bolts and screws - general purpose, nuts - general purpose.
| Committee |
FME/9
|
| DevelopmentNote |
Reviewed and confirmed by BSI, November, 2004. (11/2004)
|
| DocumentType |
Standard
|
| Pages |
38
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy |
A newer version of this standard is available.
View Current Edition
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.