BS 3734:1978
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Specification for dimensional tolerances of solid moulded and extruded rubber products
Hardcopy , PDF
English
31-10-1978
15-01-1997
Foreword
Cooperating organizations
Specification
0 Introduction
1 Scope and field of application
2 References
Section one. Mouldings
3 Definitions
4 Tolerances
5 Measurement of dimensions
Section two. Extrusions
6 Tolerances
7 Measurement of dimensions
Tables
1 Tolerances for moulded products
2 Tolerances on cross-sectional dimensions
3 Tolerances on internal dimensions of mandrel-
supported extrusions
4 Tolerances on outside dimensions of surface-ground
extrusions
5 Tolerances on wall thickness of surface-ground
extrusions
6 Tolerances on cut length of extrusions
7 Tolerances on thickness of cut sections
Figure
Compression mould and moulded part (diagrammatic)
Four classes of tolerance for moulded products and various classes of tolerances on extruded products.
| Committee |
PRI/70
|
| DocumentType |
Standard
|
| Pages |
12
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| Standards | Relationship |
| ISO 3302:1990 | Identical |
A newer version of this standard is available.
View Current Edition
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.