BS 4300-15(1973) : 1973
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
WROUGHT ALUMINIUM AND ALUMINIUM ALLOYS FOR GENERAL ENGINEERING PURPOSES (SUPPLEMENTARY SERIES) - 7020 BAR, EXTRUDED ROUND TUBE AND SECTIONS
Hardcopy , PDF
English
01-01-1973
15-06-2001
Co-operating organizations
Foreword
Specification
1 General
1.1 Scope
1.2 Definitions
2 General requirements
2.1 General
2.2 Freedom from defects
2.3 Chemical composition
2.4 Condition
2.5 Sizes and tolerances
2.6 Selection of test samples
2.7 Mechanical tests
2.8 Retests
2.9 Certificate of compliance
2.10 Inspection
2.11 Independent test
2.12 Facilities for testing
2.13 The rounding of numbers rule
3 Specific requirements
3.1 Chemical composition
3.2 Mechanical properties
3.3 Tolerances
3.4 Normal radii for corners
Appendices
A Standard sizes of material
B Details of the international alloy designations
and chemical composition limits for wrought
aluminium alloys system
Tables
1 Heat-treatable materials; grouping into batches
2 Table deleted
3 Tensile test
4 Tolerances on diameter and length of round bar
intended for use on automatic lathes
5 Tolerances on width across flats of hexagonal bar
for nuts and bolts
6 Tolerances on length
7 Tolerances on width and diameter of bars and
regular sections
8 Tolerances on thickness of bars and regular
sections
9 Tolerances on open ends of channels and I-beams
10 Angular tolerances for extruded sections
11 Tolerances on wall thickness of extruded round
tube
12 Tolerances on outside diameter of extruded round
tube or on inside diameter of Class A and Class B
extruded round tubing
13 Tolerances on width or width across flats of
hollow sections
14 Tolerances on thickness of hollow sections
15 Tolerances on straightness for extruded bar,
regular sections and extruded round tube
16 Tolerances on twist for extruded solid and hollow
sections
17 Normal radii for corners
Figure
1 Tolerances on open ends of channels and I-beams
Describes aluminium alloy bar, extruded round tube and sections, including freedom from defects, chemical composition, condition, sizes and tolerances, selection of test samples, mechanical tests, retests, certificate of compliance, inspection, independent test, facilities for testing and the rounding of numbers rule.
| Committee |
NFM/35
|
| DocumentType |
Standard
|
| Pages |
26
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.