BS 6160-5:1989

National foreword
Committees responsible
Section one - General
1. Scope
2. Object
Section two - Supplementary definitions and conditions
of measurement
3. Supplementary terms and definitions
4. Standard test conditions
5. Supplementary test conditions
6. Characteristics of the measuring equipment
Section three - Methods of measurement for receivers
equipped with suitable antenna terminals
7. Reference sensitivity
8. Audio-frequency response
9. Total distortion factor
10. Relative audio-frequency intermodulation product
     level
11. Squelch characteristics
12. Signal-to-residual output-power ratio
13. Impulsive noise
14. Selectivity
15. Automatic gain-control (A.G.C.) characteristics
16. Radiated spurious emission (under consideration)
17. Conducted spurious components
18. Evaluation of the receiving part of the equipment
     under duplex conditions
19. Receiver performance under conditions deviating
     from standard test conditions
Section four - Methods of measurement for receivers
with integral antennas
20. Reference (radiation) sensitivity
21. Average radiation sensitivity
22. Remarks on measurements requiring the use of a
     coupling device (radio-frequency and/or acoustic)
23. Reference sensitivity (RFCD)
24. Audio-frequency response (RFCD)
25. Total distortion factor
26. Relative audio-frequency intermodulation product
     level
27. Squelch characteristics
28. Signal-to-residual output-level ratio
29. Selectivity
30. Automatic gain control (A.G.C.) characteristics
Appendix A - Examples of combining networks
Appendix B - Supplementary recommended methods for
             testing measuring arrangements
Appendix C - General information on impulsive noise and
             random-impulse generator
Appendix D - Intermodulation response
Appendix E - Example of a mains power line impedance
             stabilization network
Appendix F - Guidelines for measuring, on a radiation
             test site or in a radio-frequency coupling
             device (RFCD), the audio-frequency output
             of a receiver having an integral transducer
Appendix G - Guide for the construction of a 30 m
             radiation test site for equipment receiving
             radio-frequency electromagnetic energy
Appendix H - Guide for the construction of a 3 m
             radiation test site for measurements above
             100 MHz of equipment emitting radio-
             frequency electromagnetic energy
Appendix J - Guide for the construction and measurement
             of a radio-frequency coupling device (RFCD)
Appendix K - Alternative test mounting arrangements for
             equipment which is hand-carried or carried
             on the person while in normal operation
Appendix L - Guide for the construction of a 30 m
             radiation test site for equipment emitting
             radio-frequency electromagnetic energy