BS 6697:1986
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Methods of test for electrohydraulic proportional control valves
Hardcopy , PDF
English
30-04-1986
15-01-2000
Foreword
Committees responsible
Method
1 Scope
2 Definitions
3 Symbols and units
4 Standard test conditions
5 Test installation
6 Electrical tests
7 Flow control tests
8 Pressure control tests
9 Endurance tests
10 Pressure impulse test
11 Environmental tests
12 Presentation of results
Appendices
A Guidance on conducting the tests
B Errors and classes of measurement
Tables
1 Symbols and units
2 Standard test conditions
3 Permissible systematic errors of measuring
instruments as determined during calibration
Figures
1 Typical steady-state test circuit for flow control
valves
2 Typical dynamic test circuit for flow control valves
3 Alternative test circuits for two-way pressure
control valves
4 Electronic impedance measurement test
5 Control flow versus input signal at constant valve
pressure drop
6 Control flow versus load pressure drop
7 Control flow versus fluid temperature
8 Transient responses of a flow control valve
9 Control pressure versus input signal
10 Control pressure versus flow
11 Graphical presentation of transient response of a
pressure control valve
Production acceptance and type (or qualification) tests. Applicable to 2-, 3- and 4-way flow control valves and to 2-way pressure control valves.
| Committee |
MCE/18
|
| DocumentType |
Standard
|
| Pages |
24
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy |
| BS 4062-2:1982 | Valves for hydraulic fluid power systems Methods for determining performance |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.