BS 7854-1(1996) : 1996
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
MECHANICAL VIBRATION - EVALUATION OF MACHINE VIBRATION BY MEASUREMENTS ON NON-ROTATING PARTS - GENERAL GUIDELINES
Hardcopy , PDF
English
01-01-1996
28-02-2010
Committees responsible
National foreword
Introduction
Guide
1 Scope
2 Normative references
3 Measurements
4 Instrumentation
5 Evaluation criteria
Annexes
A (informative) Vibratory waveform relationships
B (informative) Interim broad-band vibration criteria
for specific machine groups
C (informative) General guidelines for specification
of criteria
D (informative) Vector analysis of change in vibration
E (informative) Specialist measurement and analysis
techniques for detection of problems in rolling-
element bearing
Table
B.1 Typical zone boundary limits
Figures
1 Measuring points for pedestal bearings
2 Measuring points for housing-type bearings
3 Measuring points for small electrical machines
4 Measuring points for reciprocating engines
5 Measuring points for vertical machine sets
6 General form of vibration velocity acceptance
criteria
A.1 Relationship between acceleration, velocity and
displacement for single-frequency harmonic components
D.1 Comparison of vector change and change in magnitude
for a discrete frequency component
Establishes general conditions and procedures for the measurement and evaluation of vibration using measurements made on non-rotating (and sometimes non-reciprocating) parts of complete machines. Does not cover torsional vibration.
| Committee |
GME/21
|
| DevelopmentNote |
Supersedes 93/706301 DC and BS 4675-1(1976). (10/2005) Renumbered and superseded by BS ISO 10816-1. (02/2010)
|
| DocumentType |
Standard
|
| Pages |
26
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| ISO 7919-4:2009 | Mechanical vibration — Evaluation of machine vibration by measurements on rotating shafts — Part 4: Gas turbine sets with fluid-film bearings |
| ISO 7919-2:2009 | Mechanical vibration — Evaluation of machine vibration by measurements on rotating shafts — Part 2: Land-based steam turbines and generators in excess of 50 MW with normal operating speeds of 1 500 r/min, 1 800 r/min, 3 000 r/min and 3 600 r/min |
| ISO 7919-5:2005 | Mechanical vibration — Evaluation of machine vibration by measurements on rotating shafts — Part 5: Machine sets in hydraulic power generating and pumping plants |
| ISO 2041:2009 | Mechanical vibration, shock and condition monitoring — Vocabulary |
| BS 6749-1:1986 | Measurements and evaluation of vibration on rotating shafts Guide to general principles |
| ISO 2954:2012 | Mechanical vibration of rotating and reciprocating machinery — Requirements for instruments for measuring vibration severity |
| ISO 7919-3:2009 | Mechanical vibration — Evaluation of machine vibration by measurements on rotating shafts — Part 3: Coupled industrial machines |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.