BS EN 12897:2016
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Water supply. Specification for indirectly heated unvented (closed) storage water heaters
Hardcopy , PDF
English
30-06-2016
01-04-2020
European foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and symbols
4 Requirements
5 Marking
6 Evaluation of conformity
7 Technical documents
Annex A (normative) - Hot water safety and performance
testing
Annex B (normative) - Measurement of standing heat loss
for factory insulated storage water heaters
Annex C (informative) - Inspection access
Annex ZA (informative) - Relationship between this
European Standard and the requirements of Commission
Delegated Regulation (EU) No 812/2013 of February 2013
supplementing Directive 2010/30/EU regarding energy
labelling for water heaters and hot water storage tanks
Annex ZB (informative) - Relationship between this European
Standard and the requirements of Commission Regulation
(EU) No 814/2013 of 2 August 2013 implementing Directive
2009/125/EC with regard to Ecodesign requirements for
water heaters and hot water storage tanks
Bibliography
Defines the constructional and performance requirements and methods of test for indirectly heated, unvented (closed) storage water heaters of up to 2000 l volume suitable for connection to a water supply at a pressure between 0,05 MPa and 1,0 MPa (0,5 bar and 10 bar), and fitted with control and safety devices designed to prevent the temperature of the stored drinking water from reaching 95 degrees C.
| Committee |
B/504/-/10
|
| DevelopmentNote |
Supersedes BS 7206(1990) and 97/104479 DC. (06/2007) Supersedes 14/30287372 DC. (06/2016)
|
| DocumentType |
Standard
|
| Pages |
36
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
This European Standard specifies the constructional and performance requirements and methods of test for indirectly heated, unvented (closed) storage water heaters of up to 2 000 l volume suitable for connection to a water supply at a pressure between 0,05 MPa and 1,0 MPa (0,5 bar and 10 bar), and fitted with control and safety devices designed to prevent the temperature of the stored drinking water from reaching 95 °C. Whilst storage water heaters intended primarily for direct heating are not covered by this standard, it does allow the provision of electric heating elements for auxiliary use.
| Standards | Relationship |
| NBN EN 12897 : 2016 | Identical |
| DIN EN 12897:2006-09 | Identical |
| I.S. EN 12897:2016 | Identical |
| EN 12897:2016 | Identical |
| NEN EN 12897 : 2016 | Identical |
| NF EN 12897 : 2016 | Identical |
| NS EN 12897 : 2006 | Identical |
| DIN EN 12897:2016-12 | Equivalent |
| DIN EN 12897:2016-12 | Identical |
| UNE-EN 12897:2017 | Identical |
A newer version of this standard is available.
View Current Edition
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.