BS EN 60806:2004
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Determination of the maximum symmetrical radiation field from a rotating anode X-ray tube for medical diagnosis
Hardcopy , PDF
English
31-08-2006
20-01-2023
INTRODUCTION
1 Scope and object
1.1 Scope
1.2 Object
2 Terminology
2.1 Degree of requirements
2.2 Definitions
3 Other international standards
4 Maximum symmetrical RADIATION FIELD
4.1 Orientation of the maximum symmetrical RADIATION
FIELD
4.2 Distribution of AIR KERMA RATE
4.3 Maximum AIR KERMA RATE
5 Measurement of the distribution of AIR KERMA RATE
5.1 Measuring arrangement
5.2 Measuring conditions
6 Compliance
6.1 Assessment of compliance
6.2 Statement of compliance
APPENDIX A - Index of terms
APPENDIX B - Determination of AIR KERMA RATE by radiographic
densitometric measurement
Applies to X-RAY SOURCE ASSEMBLIES and X-RAY TUBE ASSEMBLIES containing ROTATING ANODE X-RAY TUBES, for use in MEDICAL DIAGNOSTIC RADIOLOGY for techniques in which the X-RAY PATTERN will be received simultaneously in all points of the IMAGE RECEPTION AREA.
| Committee |
CH/62/2
|
| DevelopmentNote |
Supersedes BS 6628(1985). (08/2006)
|
| DocumentType |
Standard
|
| Pages |
14
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1 Scope This standard is applicable to x-ray source assemblies and x-ray tube assemblies containing rotating anode x-ray tubes, for use in medical diagnostic radiology for techniques in which the x-ray pattern will be received simultaneously in all points of the image reception area. Unless otherwise specified, this standard is applicable to an x-ray tube assembly with a brand-new rotating anode x-ray tube. This standard does not apply to x-ray source assemblies and x-ray tube assemblies for special applications, when for example steeper variations of the air kerma rate or particular distributions are intended. 1.2 Object This standard describes a method for the determination of the greatest geometrically symmetrical radiation field at a specified distance from the focal spot for which the percentage air kerma rate along the major axes does not fall below a permitted value. Fig. 1 Typical distribution of the relative air kerma rate along the major axis X of a maximum symmetrical radiation field
| Standards | Relationship |
| EN 60806:2004 | Identical |
| IEC 60806:1984 | Identical |
| I.S. EN 60806:2004 | Identical |
| NBN EN 60806 : 2005 | Identical |
| NF EN 60806 : 2004 | Identical |
| DIN EN 60806:2006-04 | Identical |
| UNE-EN 60806:2005 | Identical |
| ISO 5-4:2009 | Photography and graphic technology — Density measurements — Part 4: Geometric conditions for reflection density |
| ISO 5-3:2009 | Photography and graphic technology — Density measurements — Part 3: Spectral conditions |
| ISO 5-1:2009 | Photography and graphic technology — Density measurements — Part 1: Geometry and functional notation |
| ISO 5-2:2009 | Photography and graphic technology — Density measurements — Part 2: Geometric conditions for transmittance density |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.