BS EN 61000-4-30:2015
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Electromagnetic compatibility (EMC) Testing and measurement techniques. Power quality measurement methods
Hardcopy , PDF
English
28-02-2017
07-05-2021
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 General
5 Power quality parameters
6 Performance verification
Annex A (informative) - Power quality
measurements - Issues and guidelines
Annex B (informative) - Power quality
measurement - Guidance for applications
Annex C (informative) - Conducted emissions
in the 2 kHz to 150 kHz range
Annex D (informative) - Underdeviation and
overdeviation
Annex E (informative) - Class B Measurement
Methods
Bibliography
Annex ZA (normative) - Normative references to
international publications with their
corresponding European publications
Describes the methods for measurement and interpretation of results for power quality parameters in a.c. power supply systems with a declared fundamental frequency of 50 Hz or 60 Hz.
| Committee |
GEL/210
|
| DevelopmentNote |
Supersedes 99/245066 DC. (07/2003) Supersedes 06/30150602 DC & 06/30159310 DC. (04/2009) 2009 Edition remains active & will be withdrawn on 27/03/2018. Supersedes 12/30262567 DC. (04/2015)
|
| DocumentType |
Standard
|
| Pages |
74
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
This part of IEC61000‑4 defines the methods for measurement and interpretation of results for power quality parameters in a.c. power supply systems with a declared fundamental frequency of 50Hz or 60Hz. Measurement methods are described for each relevant parameter in terms that give reliable and repeatable results, regardless of the method’s implementation. This standard addresses measurement methods for in-situ measurements. Measurement of parameters covered by this standard is limited to conducted phenomena in power systems. The power quality parameters considered in this standard are power frequency, magnitude of the supply voltage, flicker, supply voltage dips and swells, voltage interruptions, transient voltages, supply voltage unbalance, voltage harmonics and interharmonics, mains signalling on the supply voltage, rapid voltage changes, and current measurements. Emissions in the 2kHz to 150kHz range are considered in AnnexC (informative), and over- and underdeviations are considered in AnnexD (informative). Depending on the purpose of the measurement, all or a subset of the phenomena on this list may be measured. NOTE1 Test methods for verifying compliance with this standard can be found in IEC62586‑2 . NOTE2 The effects of transducers inserted between the power system and the instrument are acknowledged but not addressed in detail in this standard. Guidance about effects of transducers can be found IECTR61869‑103 .
| Standards | Relationship |
| DIN EN 61000-4-30 : 2016 | Identical |
| I.S. EN 61000-4-30:2015 | Identical |
| NF EN 61000-4-30 : 2015 | Identical |
| EN 61000-4-30:2015 | Equivalent |
| IEC 61000-4-30:2015 RLV | Identical |
| UNE-EN 61000-4-30:2015 | Identical |
A newer version of this standard is available.
View Current Edition
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.