BS EN ISO 2566-1:1999
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Steel. Conversion of elongation values Carbon and low alloy steels
Hardcopy , PDF
English
15-09-1999
25-01-2022
| Committee |
ISE/101
|
| DevelopmentNote |
Supersedes BS 3894-1(1965). (09/2005) Reviewed and confirmed by BSI, September 2007. (09/2007)
|
| DocumentType |
Standard
|
| Pages |
36
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
This part of ISO2566 specifies a method of converting room temperature percentage elongations after fracture obtained on various proportional and non-proportional gauge lengths to other gauge lengths. The formula (see clause4) on which conversions are based is considered to be reliable when applied to carbon, carbon manganese, molybdenum and chromium molybdenum steels within the tensile strength range 300 to 700N/mm2 and in the hot-rolled, hot-rolled and normalized or annealed conditions, with or without tempering. These conversions are not applicable to cold reduced steels; quenched and tempered steels; austenitic steels. Neither should they be used where the gauge length exceeds 25 or where the width to thickness ratio of the test piece exceeds 20. Care should be exercised in the case of strip under 4mm thickness, as the index in the formula given in clause4 increases with decreasing thickness; the value to be used shall be the subject of agreement between the customer and the supplier.
| Standards | Relationship |
| NEN EN ISO 2566-1 : 1999 | Identical |
| NS EN ISO 2566-1 : 1ED 1999 | Identical |
| I.S. EN ISO 2566-1:1999 | Identical |
| NBN EN ISO 2566-1 : 1ED 99 | Identical |
| ISO 2566-1:1984 | Identical |
| NF EN ISO 2566-1 : 1999 | Identical |
| EN ISO 2566-1:1999 | Identical |
| DIN EN ISO 2566-1:1999-09 | Equivalent |
| DIN EN ISO 2566-1:1999-09 | Identical |
| UNE-EN ISO 2566-1:2000 | Identical |
A newer version of this standard is available.
View Current Edition
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.