BS EN ISO 75-3:2004
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Plastics. Determination of temperature of deflection under load High-strength thermosetting laminates and long-fibre-reinforced plastics
Hardcopy , PDF
English
31-08-2006
15-08-2025
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Principle
5 Apparatus
6 Test specimens
7 Conditioning
8 Procedure
9 Expression of results
10 Precision
11 Test report
Bibliography
Provides a method for the determination of the temperature of deflection under load of high-strength thermosetting laminates and compression-moulded long-fibre-reinforced plastics in which the fibre length is greater than 7,5 mm.
| Committee |
PRI/21
|
| DevelopmentNote |
Renumbers and Supersedes BS 2782-1.121D(1994). 1996 version incorporates amendment 8645 to BS 2782-1.121D(1994). (9/1996) Supersedes 01/121040 DC. (06/2004)
|
| DocumentType |
Standard
|
| Pages |
16
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| Standards | Relationship |
| DIN EN ISO 75-3:2004-09 | Identical |
| NBN EN ISO 75-3 : 2004 COR 2006 | Identical |
| ISO 75-3:2004 | Identical |
| NF EN ISO 75-3 : 2005 | Identical |
| NEN EN ISO 75-3 : 2004 C11 2007 | Identical |
| NS EN ISO 75-3 : 2ED 2004 | Identical |
| I.S. EN ISO 75-3:2004 | Identical |
| EN ISO 75-3:2004 | Equivalent |
| EN ISO 75-3:2004/AC:2006 | Identical |
| UNE-EN ISO 75-3:2005 | Identical |
| BS 7825-3.1:1997 | Calibration of rubber and plastics test equipment. Calibration schedules Thermal properties |
| ISO 75-1:2013 | Plastics — Determination of temperature of deflection under load — Part 1: General test method |
| ISO 295:2004 | Plastics — Compression moulding of test specimens of thermosetting materials |
| ISO 10350-1:2017 | Plastics — Acquisition and presentation of comparable single-point data — Part 1: Moulding materials |
| ISO 10724-1:1998 | Plastics — Injection moulding of test specimens of thermosetting powder moulding compounds (PMCs) — Part 1: General principles and moulding of multipurpose test specimens |
| ISO 14125:1998 | Fibre-reinforced plastic composites — Determination of flexural properties |
| ISO 2818:1994 | Plastics — Preparation of test specimens by machining |
| ISO 178:2010 | Plastics — Determination of flexural properties |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.