BS IEC 1000-3.5 : 1994
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Hardcopy , PDF
English
01-01-1994
28-02-2010
INTRODUCTION
1 Scope
2 Normative References
3 Definitions
4 Equipment assessment
4.1 General
4.2 Information from the consumer
4.3 Information from the electricity supplier
4.4 Information from the manufacturer
4.5 Measurement procedure for the type test for
equipment with a rated input current up to 75 A
4.5.1 Test impedance Z*
4.5.2 Test of equipment against Z*
4.5.3 Evaluation against Zref
4.6 Evaluation and declaration by the manufacturer
of equipment with a rated input current up to
75 A
4.6.1 Check of the measured values against the
limits contained in IEC 1000-3-3
4.6.2 Calculation of the maximum permissable
system impedance
4.7 Evaluation of equipment with a rated input
current exceeding 75 A
Annexes
A Recommended questionnaire for the consumer
B Recommended questionnaire for the electricity supplier
C Explanations
C.1 Explanation of 4.5.1
C.2 Explanation of 4.6.2
C.3 Explanation of 4.7
D Diagrammatic representation of procedures to be
followed in evaluating voltage fluctuations and
flicker disturbances caused by equipment connected to
the low-voltage public supply network
Deals with the emission of disturbances due to voltage fluctuations and flicker. Applies to electrical and electronic equipment meant to be connected to a public low-voltage a.c. distribution system, where the equipment has a rated input current over 16 A per phase, or has a lower rated current, but requires the special consent of the supply authority.
| Committee |
GEL/110
|
| DevelopmentNote |
Supersedes 90/28293 DC. (06/2005)
|
| DocumentType |
Standard
|
| Pages |
12
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy |
| BS IEC 1000-2.6 : 1995 | |
| BS IEC 1000-3.7 : 1996 | ELECTROMAGNETIC COMPATIBILITY (EMC) - LIMITS - ASSESSMENT OF EMISSION LIMITS FOR FLUCTUATING LOADS IN MV AND HV POWER SYSTEMS - BASIC EMC PUBLICATION |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.