BS IEC 60034-17:1998
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Rotating electrical machines Cage induction motors when fed from converters. Application guide
Hardcopy , PDF
English
15-04-1999
16-08-2002
INTRODUCTION
1 Scope
2 Normative references
3 Characteristics of the motor
4 Frequency spectrum of voltage and/or currents
5 Additional losses
6 Torque derating during converter operation
7 Oscillating torques
8 Magnetically excited noise
9 Service life of the insulation system
10 Shelf voltages
11 Maximum safe operating speed
Figure 1 Waveform of phase current iphase in delta
connection for l-converter supply (idealized example)
Figure 2 Waveform of phase voltage uphase in delta
connection for U-converter supply with pulse
frequency fp = 15 x f1 (example)
Figure 3 Influence of converter supply on the losses of a
cage induction motor (frame size 315 M, design N)
with rated values of torque and speed
Figure 4 Fundamental voltage U1 as a function of operating
frequency f1 (see clause 6)
Figure 5 Torque derating factor for cage induction motors
of design N, IC 0141 (self-circulating cooling)
for l-converter supply as a function of operating
frequency f1 (example)
Figure 6 Limiting curve of admissible impulse voltage ULL
(including voltage reflection and damping) at the
motor terminals as a function of the rise time ta
Figure 7 Definition of the rise time ta of the voltage at the
motor terminals
Covers the steady-state operating of cage induction motors within the scope of IEC 60034-12, when fed from converters. Describes the operation over the whole speed setting range, but is not concerned with starting or transient phenomena.
| Committee |
PEL/2
|
| DocumentType |
Standard
|
| Pages |
18
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy |
| IEC 60072-3:1994 | Dimensions and output series for rotating electrical machines - Part 3: Small built-in motors - Flange numbers BF10 to BF50 |
| IEC 60072-1:1991 | Dimensions and output series for rotating electrical machines - Part 1: Frame numbers 56 to 400 and flange numbers 55 to 1080 |
| IEC 60034-1:2017 | Rotating electrical machines - Part 1: Rating and performance |
| IEC 60072-2:1990 | Dimensions and output series for rotating electrical machines - Part 2: Frame numbers 355 to 1000 and flange numbers 1180 to 2360 |
| IEC 60034-12:2016 | Rotating electrical machines - Part 12: Starting performance of single-speed three-phase cage induction motors |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.