BS IEC 62232:2011

FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and abbreviated terms
5 Developing the evaluation plan
6 Evaluation methods
7 Uncertainty
8 Reporting
Annex A (normative) - Developing the evaluation
        plan
Annex B (normative) - Defining the source-environment
        plane
Annex C (informative) - Guidance on the application
        of the standard to specific evaluation purposes
Annex D (normative) - Evaluation parameters
Annex E (normative) - RF field strength measurement
        equipment requirements
Annex F (informative) - Basic computation implementation
Annex G (normative) - Advanced computation implementation
Annex H (normative) - Validation of computation methods
Annex I (informative) - Guidance on spatial averaging schemes
Annex J (informative) - Guidance on addressing time
        variation of signals in measurement
Annex K (informative) - Guidance on determining ambient field
        levels
Annex L (informative) - Guidance on comparing evaluated
        parameters with a limit value
Annex M (informative) - Guidance on assessment schemes
Annex N (informative) - Guidance on specific technologies
Annex O (informative) - Guidance on uncertainty
Annex P (informative) - Case studies
Bibliography

Gives methods for the determination of radio-frequency (RF) field strength and specific absorption rate (SAR) in the vicinity of radiocommunication base stations (RBS) for the purpose of evaluating human exposure.

This International Standard provides methods for the determination of radio-frequency (RF) field strength and specific absorption rate (SAR) in the vicinity of radiocommunication base stations (RBS) for the purpose of evaluating human exposure. This standard: considers RBS which transmit on one or more antennas using one or more frequencies in the range 300 MHz to 6 GHz; describes several RF field strength and SAR measurement and computation methodologies with guidance on their applicability to address both the in situ evaluation of installed RBS and laboratory-based evaluations; describes how surveyors with a sufficient level of expertise shall establish their specific evaluation procedures appropriate for their evaluation purpose; considers the evaluation purposes, namely: product conformity: to establish that a RBS conforms to a defined set of limit conditions under its intended use; compliance boundary: to establish the compliance boundary or boundaries for a RBS in relation to a defined set of limit conditions; to evaluate RF field strength or SAR values at one or more evaluation locations, namely: evaluation location(s) at arbitrary locations outside the control boundary to provide information for interested parties; evaluation location(s) at the control boundary to confirm validity of control boundary; evaluation location(s) within the control boundary with the specific conditions relevant to investigate an alleged over-exposure incident; provides guidance on how to report, interpret and compare results from different evaluation methodologies and, where the evaluation purpose requires it, determine a justified decision against a limit value; provides informative guidance on how to evaluate ambient RF field strength levels in the vicinity of a RBS from RF sources other than the RBS under evaluation and at frequencies within and outside the range 300 MHz to 6 GHz; provides short descriptions of the informative example case studies to aid the surveyor given in the companion Technical Report IEC 62669 [54].