BS ISO 294-5 : 2011
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
PLASTICS - INJECTION MOULDING OF TEST SPECIMENS OF THERMOPLASTIC MATERIALS - PART 5: PREPARATION OF STANDARD SPECIMENS FOR INVESTIGATING ANISOTROPY
Hardcopy , PDF
English
01-01-2011
30-06-2013
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Apparatus
5 Procedure
6 Report on test-specimen preparation
Annex A (normative) - Preparation of test specimens
Describes a two-cavity mould (designated the type F ISO mould) for the injection moulding of 80 mm x 90 mm plates with a preferred thickness of 2 mm for single-point data acquisition because 2 mm has been found to provide the maximum anisotropic properties, with only a slight sensitivity to the rate of injection.
| Committee |
PRI/21
|
| DevelopmentNote |
Supersedes 07/30169634 DC. (05/2011) Renumbered and superseded by BS EN ISO 294-5. (06/2013)
|
| DocumentType |
Standard
|
| Pages |
18
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| Standards | Relationship |
| ISO 294-5:2017 | Identical |
| ISO 527-2:2012 | Plastics — Determination of tensile properties — Part 2: Test conditions for moulding and extrusion plastics |
| ISO 294-1:2017 | Plastics — Injection moulding of test specimens of thermoplastic materials — Part 1: General principles, and moulding of multipurpose and bar test specimens |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.