BS ISO TR 10064-2:1996
Current
The latest, up-to-date edition.
Code of inspection practice Inspection related to radial composite deviations, runout, tooth thickness and backlash
Hardcopy , PDF
English
29-12-2006
Foreword
1 Scope
2 References
3 Symbols, corresponding terms and definitions
3.1 Lower case symbols
3.2 Upper case symbols
3.3 Greek symbols
3.4 Subscript symbols
3.5 Definitions
4 Measurement of radial composite deviations
4.1 Checking principle
4.2 The utility of radial composite deviation data
5 Measurement of runout, determining eccentricity
5.1 Measuring principle
5.2 Anvil size for measuring runout
5.3 Measuring runout
5.4 Evaluation of measurement
5.5 Value of runout measurement
5.6 The relation between runout and pitch deviations
6 Measurement of tooth thickness, tooth span and
dimension over balls or cylinders
6.1 Tooth thickness measurement
6.2 Span measurement
6.3 Control of tooth thickness by determining the
dimension over balls or cylinders
6.4 Tooth thickness measurement with radial composite
measurement
6.5 Calculations for radial composite action test
measurement
7 Gear limits and fits
7.1 Introduction
7.2 Tooth thickness tolerances
Annex A Backlash and tooth thickness tolerance
A.1 Purpose
A.2 Backlash
A.3 Maximum tooth thickness
A.4 Minimum backlash
A.5 Specifications for tooth thickness measurement
A.6 Maximum backlash
Annex B Bibliography
Consists a code of practice dealing with inspection relevant to radial composite deviations, runout, tooth thickness and backlash of cylindrical involute gears; i.e., with measurements referred to double flank contact.
| Committee |
MCE/5
|
| DevelopmentNote |
Reviewed and confirmed by BSI, December 2005. (11/2005)
|
| DocumentType |
Standard
|
| Pages |
42
|
| PublisherName |
British Standards Institution
|
| Status |
Current
|
This part of the Technical Report constitutes a code of practice dealing with inspection relevant to radial composite deviations, runout, tooth thickness and backlash of cylindrical involute gears; i.e., with measurements referred to double flank contact.
In providing advice on gear checking methods and the analysis of measurement results, it supplements the standard ISO 1328-2. Most of the terms used are defined in ISO 1328-2.
Annex A provides a method to select gear tooth thickness tolerances and minimum backlash of a gear mesh. Suggested values for minimum backlash are included.
| Standards | Relationship |
| ISO/TR 10064-2:1996/Cor 2:2006 | Identical |
| ISO/TR 10064-2:1996 | Identical |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.