Customer Support: 131 242

Your region & currency

Australia English(AU)

Pricing in AUD $

Local sites

  • Shopping Cart
    There are no items in your cart

We noticed you are browsing from United States. Switch to our United States site for local pricing in USD.

Dismiss alert
Wiring Rules bundle. AS/NZS 3000 + 3008.1.1 with 10% off already included. Shop Now

CLC/TS 60034-20-1:2004

Current

Current

The latest, up-to-date edition.

Rotating electrical machines - Part 20-1: Control motors - Stepping motors

Published date

10-09-2004

Sorry this product is not available in your region.
Summarise this standard

FOREWORD
1 Scope
2 Normative references
3 Definitions
4 Symbols for quantities and their units
5 Dimensions
   5.1 Type 1 motors (based on metric dimensions)
   5.2 Type 2 motors (based on imperial dimensions)
6 Test methods and acceptance criteria
   6.1 Shaft extension run-out, concentricity of
        spigot diameter and perpendicularity of mounting
        face to shaft
   6.2 Moment of inertia of rotor
   6.3 Voltage withstand test
   6.4 Thermal resistance R[th] and thermal time
        constant tau[th]
   6.5 Back e.m.f. constant
   6.6 Motor inductance
   6.7 DC resistance
   6.8 Step angle error
   6.9 Detent torque
   6.10 Holding torque
7 Special tests
   7.1 General
   7.2 Winding temperature rise
   7.3 Torque displacement curve
   7.4 Single step response, natural frequency and
        settling time
   7.5 Maximum slew rate
   7.6 Pull-in rate
   7.7 Pull-out torque
   7.8 Maximum reversing rate
   7.9 Resonance
8 Rating plate and other information
   8.1 Rating plate
   8.2 Typical modes
   8.3 Values to be indicated by the manufacturer
   8.4 Lead identification and terminal numbering
   8.5 Catalogue presentation
   8.6 Basic performance curves
9 EMC requirements
10 Safety requirements
Annex A (Informative) Test procedures
Annex B (Informative) Special tests
Annex ZA (normative) Normative references to international
         publications with their corresponding European publications

Gives the requirements for rotating control motors and describes the appropriate tests. Also gives dimensions and marking information and the details to be provided by the manufacturer in associated data sheets and catalogues. Applicable to rotating stepping motors only.

Committee
CLC/TC 2
DocumentType
Technical Specification
PublisherName
European Committee for Standards - Electrical
Status
Current

Sorry this product is not available in your region.