DEFSTAN 59-41(PT5)/3(2003) : 2003
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
ELECTROMAGNETIC COMPATIBILITY - PART 5: PERFORMANCE SPECIFICATION FOR SPECIALISED EMC TEST EQUIPMENT
12-01-2013
23-01-2007
DESCRIPTION
CONTENT
PREFACE
MAIN TEXT
SECTION 1 - GENERAL REQUIREMENTS
0 INTRODUCTION
1 SCOPE
2 WARNING
3 RELATED DOCUMENTS
4 DEFINITIONS
5 ABBREVIATIONS
SECTION 2 - GENERATORS AND CALIBRATION JIGS
6 GENERATORS AND CALIBRATION JIGS
7 TRANSIENT GENERATOR PERFORMANCE SPECIFICATIONS
7.1 Type 1: DCS04.3 variable frequency transient generator
7.2 Type 1N: DCS05.2 & DCS05.3 variable frequency transient
generator
7.3 Type 2: DCS04.3, DCS06.2 & DCS06.3 fixed frequency
generator
7.4 Types 1A/M and 1B: DCS08.3 variable frequency transient
generators
7.5 Type 3: DCS09.3 pulse generators
8 INJECTION PROBE PERFORMANCE SPECIFICATIONS
9 CALIBRATION JIGS
9.1 Bulk current Jigs
9.2 ESD 2 ohm calibration resistance
9.3 Specification of calibration jigs
SECTION 3 - MONITOR LOOPS AND VOLTAGE PROBES
10 MONITOR LOOPS AND VOLTAGE PROBES
10.1 Monitor loop - test methods DCS04.3 and DSC
10.2 Voltage probes - test method DCE01 (Part 4)
11 INTENTIONALLY LEFT BLANK
SECTION 4 - LISN
12 LINE IMPEDANCE STABILIZING NETWORK (LISN)
12.1 Impedance/frequency characteristic
12.2 Constructional details (not mandatory)
12.3 Calibration
SECTION 5 - SCREENED ROOMS
13 METHOD FOR DAMPING SCREENED ROOMS
13.1 Aim
13.2 Objective
13.3 Introduction
13.4 Possible procedure to partially line a screened room
SECTION 5 - SCREENED ROOMS
14 SCREENED ROOM DAMPING PERFORMANCE VERIFICATION PROCEDURE
14.1 Aim
14.2 Introduction
14.3 Objective
14.4 Test equipment
14.5 Method of measuring damping performance of screened
rooms without a ground plane
14.6 Method of measuring damping performance in
screened rooms with a ground plane
14.7 Transmitting Antenna Calibration - applicable
to screened rooms with a ground plane
SECTION 6 - VOLTAGE PROBES
15 VOLTAGE PROBES - TEST METHOD DCE03.3, DCS01.2 & DCS01.3
Defines the performance requirements for transient and pulse generators.
| DevelopmentNote |
Supersedes DEFSTAN 59-41(PT5)/2(1998), DEFSTAN 59-41(PT5)/1(1995) & DEFSTAN 59-41(PT5)/1(1990) (03/2003)
|
| DocumentType |
Standard
|
| PublisherName |
UK Ministry of Defence Standards
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| DEFSTAN 02-101(PT1)/2(2005) : 2005 | REQUIREMENTS FOR DESIGN AND FITTING OUT OF WORKSHOPS MAINTENANCE SPACES AND ENGINEERING STORES FOR HM SURFACE SHIPS - PART 1: COMMON REQUIREMENTS |
| DEFSTAN 00-18(PT1)SEC2/2(1991) : 1991 | AVIONIC DATA TRANSMISSION INTERFACE SYSTEMS - PART 1: GUIDE TO INTERFACE SYSTEMS - SEC 2: GUIDE TO THE SERIAL, TIME DIVISION, COMMAND/RESPONSE MULTIPLEX DATA BUS STANDARD |
| DEFSTAN 00-18(PT1)SEC4/3(1995) : 1995 | AVIONICS DATA TRANSMISSION INTERFACE SYSTEMS - PART 1: GUIDE TO INTERFACE SYSTEMS - SECTION 4: GUIDE TO THE DISCRETE SIGNAL INTERFACES STANDARD |
| BS EN 55022:2010 | Information technology equipment. Radio disturbance characteristics. Limits and methods of measurement |
| DEFSTAN 61-5(PT6)/5(1990) : 1990 AMD 1 1994 | ELECTRICAL POWER SUPPLY SYSTEMS BELOW 650 VOLTS - PART 6: 28 VOLT DC ELECTRICAL SYSTEMS IN MILITARY VEHICLES |
| DEFSTAN 61-5(PT1)/3(1992) : 1992 | ELECTRICAL POWER SUPPLY SYSTEMS BELOW 650 VOLTS - PART 1: TERMINOLOGY AND DEFINITIONS |
| DEFSTAN 21-27/1(2000) : 2000 | ELECTROMAGNETIC COMPATIBILITY REQUIREMENTS FOR INSTALLATIONS IN SHIPS |
| DEFSTAN 08-136(PT2)/1(2000) : 2000 | REQUIREMENTS FOR ELECTROMAGNETIC ENGINEERING - CATEGORY 2 - PART 2: GUIDE TO THE APPLICATION OF ELECTROMAGNETIC ENGINEERING |
| DEFSTAN 05-123/1(1983) : 1983 | TECHNICAL PROCEDURES FOR THE PROCUREMENT OF AIRCRAFT, WEAPON AND ELECTRONIC SYSTEMS |
| DEFSTAN 08-50/1(2000) : 2000 | INSTALLATION GUIDANCE FOR MEETING THE REQUIREMENTS OF NAVAL TEMPEST TESTING |
| DEFSTAN 08-112/1(2000) : 2000 | CODE OF PRACTICE FOR ELECTROMAGNETIC COMPATIBILITY TRIALS FOR HM SUBMARINES - CATEGORY 2 |
| DEFSTAN 08-107/2(2001) : 2001 | GENERAL REQUIREMENTS FOR THE DESIGN OF ELECTROMECHANICAL AND NAVAL WEAPON EQUIPMENT - CATEGORY 2 |
| DEFSTAN 08-5/1(1984) : 1984 ADDENDUM 1998 | DESIGN REQUIREMENTS FOR WEAPON SYSTEMS (GUIDED WEAPONS, TORPEDOES AND AIRBORNE ARMAMENT STORES) |
| DEFSTAN 61-5(PT4)/2(1992) : 1992 | ELECTRICAL POWER SUPPLY SYSTEMS BELOW 650 VOLTS - PART 4: POWER SUPPLIES IN HM SHIPS |
| DEFSTAN 08-46/2(2002) : 2002 AMD 2 2004 | THE ELECTRIC, MAGNETIC AND ELECTROMAGNETIC ENVIRONMENT |
| DEFSTAN 08-136(PT1)/1(2000) : 2000 | REQUIREMENTS FOR ELECTROMAGNETIC ENGINEERING - CATEGORY 2 - PART 1: ELECTROMAGNETIC ENGINEERING MANAGEMENT |
| BS EN 60801-2:1993 | Electromagnetic compatibility for industrial-process measurement and control equipment Electrostatic discharge requirements |
| BS CISPR 12:1997 | Vehicles, motorboats and spark-ignited engine-driven devices. Radio disturbance characteristics. Limits and methods of measurement |
| BS 1597:1985 | Specification for limits and methods of measurement of electromagnetic interference generated by marine equipment and installations |
| DEFSTAN 58-6/1(1991) : 1991 | |
| DEFSTAN 05-74/1(1989) : 1989 | GUIDE TO THE PRACTICAL SAFETY ASPECTS OF THE USE OF RADIO FREQUENCY ENERGY |
| DEFSTAN 00-35/2(1996) : 1996 AMD 1 1997 | ENVIRONMENTAL HANDBOOK FOR DEFENCE MATERIEL |