DIN 743-1:2012-12
Current
The latest, up-to-date edition.
CALCULATION OF LOAD CAPACITY OF SHAFTS AND AXLES - PART 1: GENERAL
Hardcopy , PDF
German, English
01-12-2012
Foreword
Introduction
1 Scope
2 Normative references
3 Symbols, designations and units
4 Proof of avoidance of fatigue failure
5 Proof of avoidance of permanent deformation,
incipient cracking or overload breakage under
maximum load
Annex A (informative) - Explanations of the
variation of load and/or stress,
cross-sectional areas and the reading
of sigma[ADK] from the Smith diagram
Annex B (normative) - Schema of the safety factor
calculation
Bibliography
Pertains to the calculation and verification of the safety of axles and shafts against: - fatigue failure (endurance failure) if the fatigue strength is exceeded; - permanent deformation (or incipient cracking or overload breakage).
| DocumentType |
Standard
|
| Pages |
25
|
| PublisherName |
German Institute for Standardisation (Deutsches Institut für Normung)
|
| Status |
Current
|
| DIN 743-2:2012-12 | CALCULATION OF LOAD CAPACITY OF SHAFTS AND AXLES - PART 2: THEORETICAL STRESS CONCENTRATION FACTORS AND FATIGUE NOTCH FACTORS |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.