DIN 7999:1983-12
Superseded
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
HIGH TENSILE STRENGTH HEXAGON FIT BOLTS WITH LARGE WIDTH ACROSS FLATS FOR STRUCTURAL BOLTING
Available format(s)
Hardcopy , PDF
Language(s)
English
Published date
12-01-2013
Superseded date
01-03-2008
Superseded by
Including GST where applicable
1 Anwendungsbereich
2 Masse, Bezeichnung
3 Technische Lieferbedingungen
4 Klemmlängen
5 Gewichte
Zitierte Normen
Weitere Normen und andere Unterlagen
Frühere Ausgaben
Änderungen
Erläuterungen
This standard is included in DIN Handbook 10.
| DocumentType |
Standard
|
| Pages |
6
|
| PublisherName |
German Institute for Standardisation (Deutsches Institut für Normung)
|
| Status |
Superseded
|
| SupersededBy |
| DIN 18800-7:2008-11 | STEEL STRUCTURES - PART 7: EXECUTION AND CONSTRUCTER'S QUALIFICATION |
| DIN 6917:1989-10 | SQUARE TAPER WASHERS FOR I-SECTIONS FOR HIGH-TENSILE STRUCTURAL BOLTING |
| DIN 78:2013-04 | PROTRUSIONS OF BOLT ENDS |
| DIN 267-19:1984-10 | FASTENERS - TECHNICAL DELIVERY CONDITIONS - SURFACE DISCONTINUITIES ON BOLTS AND SCREWS |
| DIN ISO 898-1:1989-01 | MECHANICAL PROPERTIES OF FASTENERS - BOLTS, SCREWS AND STUDS |
| DIN 267-2:2016-01 (Draft) | FASTENERS - TECHNICAL SPECIFICATION, SURFACE ROUGHNESS FOR PRODUCT CLASSES A AND B |
| DIN 6916:1989-10 | ROUND WASHERS FOR HIGH-TENSILE STRUCTURAL BOLTING |
| DIN 13-15:1982-08 | ISO METRIC SCREW THREADS - FUNDAMENTAL DEVIATIONS AND TOLERANCES FOR SCREW THREADS FROM 1 MM NOMINAL DIAMETER AND LARGER |
| DIN 267-9:1979-08 | MECHANICAL FASTENERS - TECHNICAL CONDITIONS OF DELIVERY, COMPONENTS WITH ELECTROPLATED COATINGS |
| DIN ISO 4759-1:1980-05 | TOLERANCES FOR FASTENERS - PART 1, BOLTS, SCREWS AND NUTS WITH THREAD DIAMETERS >= 1,6 <= 150 MM AND PRODUCT GRADES A, B AND C |
| DIN 6915:1999-12 | HEXAGON NUTS WITH LARGE WIDTHS ACROSS FLATS FOR HIGH STRENGTH STRUCTURAL BOLTING |
| DIN 267-1:1982-08 | FASTENERS - TECHNICAL DELIVERY CONDITIONS - GENERAL REQUIREMENTS |
| DIN 267-5:1986-02 | FASTENERS - TECHNICAL DELIVERY CONDITIONS - ACCEPTANCE INSPECTION |
| DIN 6918:1990-04 | SQUARE TAPER WASHERS FOR U-SECTIONS FOR HIGH-TENSILE STRUCTURAL BOLTING |
Summarise