DIN EN ISO 463 : 2009-07

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Design characteristics
   4.1 General
   4.2 Dimensions
   4.3 Dial and pointer
   4.4 Revolution counting device
   4.5 Contact element
   4.6 Zero adjustment
   4.7 Movable limit
   4.8 Design characteristics (manufacturer's specification)
5 Metrological characteristics
   5.1 MPE and MPL for a number of metrological characteristics
   5.2 Contact element
   5.3 Measuring forces
6 Proving conformance with specification
   6.1 General
   6.2 Measurement standards for calibration of metrological
        characteristics
7 Marking
Annex A (informative) Example diagram of errors of indication
Annex B (informative) Example data sheet for mechanical
                      dial gauges
Annex C (informative) Calibration of metrological characteristics
Annex D (informative) Relation to the GPS matrix model
Bibliography
National Annex NA (informative) Bibliography
National Annex NB (informative) Comparison of previous practice
                                with that specified in this
                                standard

This standard is included in DIN Handbook 11-3. Describes the most important design and metrological characteristics of mechanical dial gauges.