Customer Support: 131 242

  • Shopping Cart
    There are no items in your cart
We noticed you’re not on the correct regional site. Switch to our AMERICAS site for the best experience.
Dismiss alert

DIN ISO 13165-1:2015-11

Superseded

Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by

WATER QUALITY - RADIUM-226 - PART 1: TEST METHOD USING LIQUID SCINTILLATION COUNTING (ISO 13165-1:2013)

Available format(s)

Hardcopy , PDF

Language(s)

German, English

Published date

01-01-2015

Superseded date

07-03-2021

$195.05
Including GST where applicable

National foreword
National Annex NA (informative) - Bibliography
Introduction
1 Scope
2 Normative references
3 Symbols, definitions and units
4 Principle
5 Reagents and equipment
6 Sampling
7 Instrument set-up and calibration
8 Procedure
9 Quality control
10 Expression of results
11 Interference control
12 Test report
Annex A (informative) - Set-up parameters and
        validation data
Bibliography

Describes the determination of radium-226 ([226]Ra) activity concentration in non-saline water samples by extraction of its daughter radon-222 ([222]Rn) and its measurement using liquid scintillation counting.

DocumentType
Standard
Pages
19
PublisherName
German Institute for Standardisation (Deutsches Institut für Normung)
Status
Superseded
SupersededBy

Standards Relationship
ISO 13165-1:2013 Identical

ISO/IEC 17025:2005 General requirements for the competence of testing and calibration laboratories
DIN EN ISO 80000-10:2016-09 (Draft) QUANTITIES AND UNITS - PART 10: ATOMIC AND NUCLEAR PHYSICS (ISO 80000-10:2009)
ISO 5667-3:2012 Water quality — Sampling — Part 3: Preservation and handling of water samples
DIN EN ISO 5667-1:2007-04 Water quality - Sampling - Part 1: Guidance on the design of sampling programmes and sampling techniques (ISO 5667-1:2006)
ISO 5667-1:2006 Water quality — Sampling — Part 1: Guidance on the design of sampling programmes and sampling techniques
DIN EN ISO 5667-3:2013-03 WATER QUALITY - SAMPLING - PART 3: PRESERVATION AND HANDLING OF WATER SAMPLES (ISO 5667-3:2012)
ISO 3696:1987 Water for analytical laboratory use — Specification and test methods
ISO 11929:2010 Determination of the characteristic limits (decision threshold, detection limit and limits of the confidence interval) for measurements of ionizing radiation — Fundamentals and application
DIN ISO 3696:1991-06 WATER FOR ANALYTICAL LABORATORY USE - SPECIFICATION AND TEST METHODS
ISO/IEC Guide 98-3:2008 Uncertainty of measurement — Part 3: Guide to the expression of uncertainty in measurement (GUM:1995)
ISO 80000-10:2009 Quantities and units — Part 10: Atomic and nuclear physics

$195.05
Including GST where applicable