DIN ISO 286-1:1990-11
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
ISO SYSTEM OF LIMITS AND FITS - BASES OF TOLERANCES, DEVIATIONS AND FITS
01-11-1990
01-11-2010
0 Einführung
1 Zweck
2 Anwendungsbereich
3 Verweisungen auf andere Normen
4 Begriffe
5 Kurzzeichen, Bezeichnung und Interpretationen
von Toleranzen, Abmassen und Passungen
6 Graphische Darstellung
7 Referenztemperatur
8 Grundtoleranzen für Nennmasse bis 3150 mm
9 Grundabmasse für Nennmasse bis 3150 mm
10 Verweisungen auf weitere ISO-Normen
Anhang A Grundlagen des ISO-Systems für Grenzmasse und
Passungen
Anhang B Beispiele zur Anwendung von ISO 286 Teil 1
Anhang C Bedeutungsgleiche Benennungen
This standard is included in DIN Handbook 1, 126, 303 and DIN VDE Handbook 41.
| DevelopmentNote |
Supersedes DIN 7150-1, DIN 7151, DIN 7152, DIN 7172-3 and DIN 7182-1 (07/2002)
|
| DocumentType |
Standard
|
| ProductNote |
Supersedes DIN 7150-1, DIN 7151, DIN 7152, DIN 7172-3 and DIN 7182-1 (SHM 07/2002)
|
| PublisherName |
German Institute for Standardisation (Deutsches Institut für Normung)
|
| Status |
Superseded
|
| SupersededBy |
| Standards | Relationship |
| EN 20286-1 : 1993 | Identical |
| ISO 286-1:2010 | Identical |
| ISO 8015:2011 | Geometrical product specifications (GPS) — Fundamentals — Concepts, principles and rules |
| ISO 1947:1973 | System of cone tolerances for conical workpieces from C = 1:3 to 1:500 and lengths from 6 to 630 mm |
| ISO 5166:1982 | System of cone fits for cones from C = 1 : 3 to 1 : 500, lengths from 6 to 630 mm and diameters up to 500 mm |
| ISO 2692:2014 | Geometrical product specifications (GPS) — Geometrical tolerancing — Maximum material requirement (MMR), least material requirement (LMR) and reciprocity requirement (RPR) |
| ISO 1829:1975 | Selection of tolerance zones for general purposes |
| ISO 1101:2017 | Geometrical product specifications (GPS) — Geometrical tolerancing — Tolerances of form, orientation, location and run-out |
| ISO 1:2016 | Geometrical product specifications (GPS) — Standard reference temperature for the specification of geometrical and dimensional properties |
| ISO 406:1987 | Technical drawings — Tolerancing of linear and angular dimensions |
| ISO 286-2:2010 | Geometrical product specifications (GPS) — ISO code system for tolerances on linear sizes — Part 2: Tables of standard tolerance classes and limit deviations for holes and shafts |