DR 93086
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Low voltage switchgear and controlgear Part 3: Switches, disconnectors, switch-disconnectors and fuse-combination units
15-02-2008
26-10-2017
Note - due to the age of this archived document, available information is limited therfore this record is incomplete. For further details, please phone our Customer Service Centre on 131 242 (Intl +61 2 8206 6010) or email sales@saiglobal.com.
Proposes the adoption of IEC 947-3:1990 as an Australian Standard, with the addition of Australian Appendix AA, which applies to switches, disconnectors, switch-disconnectors and fuse-combination units to be used in distribution circuits and motor circuits of which the rated voltage does not exceed 1000 V a.c. or 1500 V d.c. The provisions of the general rules are dealt with in Part 1 (IEC Publication 947-1 which has already been proposed for adoption as an Australian Standard). Australian Appendix AA proposes variations to IEC 947-3:1990 for Australian conditions. Copies of IEC 947-3:1990 may be purchased from or viewed at any Standards Australia office.
| CommentClosesDate |
30-06-1993
|
| Committee |
EL-006
|
| DocumentType |
Draft
|
| PublisherName |
Standards Australia
|
| Status |
Superseded
|
| SupersededBy |
Revision of AS 1775-1984