EN 10246-17:2000
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Non-destructive testing of steel tubes - Part 17: Ultrasonic testing of tube ends of seamless and welded steel tubes for the detection of laminar imperfections
16-02-2000
01-04-2011
FOREWORD
1 SCOPE
2 GENERAL REQUIREMENTS
3 METHOD OF TEST
4 REFERENCE STANDARDS
5 EQUIPMENT CALIBRATION AND CHECKING
6 ACCEPTANCE
7 TEST REPORTING
ANNEX A (informative) Table A.1: Parts of EN 10246 -
Non-destructive testing of steel tubes
This Part of EN 10246 specifies requirements for the full peripheral ultrasonic testing of the ends of seamless and welded tubes for the detection of laminar imperfections. The standard specifies acceptance levels and calibration procedures. This Part of EN 10246 is applicable to the inspection of welded tubes with an outside diameter greater than 30 mm. No lower limit of wall thickness is specified but see note in 3.1. European Standard EN 10246 "Non destructive testing of steel tubes" comprises the parts shown in Annex A.
| Committee |
CEN/TC 459/SC 10
|
| DocumentType |
Standard
|
| PublisherName |
Comite Europeen de Normalisation
|
| Status |
Superseded
|
| SupersededBy |
| Standards | Relationship |
| DIN EN 10246-17:2000-07 | Identical |
| I.S. EN 10246-17:2000 | Identical |
| BS EN 10246-17:2000 | Identical |
| NS EN 10246-17 : 1ED 2000 | Identical |
| NBN EN 10246-17 : 2000 | Identical |
| NF EN 10246-17 : 2000 | Identical |
| NEN EN 10246-17 : 2000 | Identical |
| PN EN 10246-17 : DEC 2002 | Identical |
| UNE-EN 10246-17:2000 | Identical |