EN 10246-3:1999
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Non-destructive testing of steel tubes - Part 3: Automatic eddy current testing of seamless and welded (except submerged arc-welded) steel tubes for the detection of imperfections
17-11-1999
01-04-2011
Foreword
1 Scope
2 Normative references
3 General requirements
4 Method of test
5 Reference standards
6 Equipment calibration and checking
7 Acceptance
8 Test reporting
Annex A (informative) Table of Parts of EN 10246 -
Non-destructive testing of steel tubes
Annex B (informative) Guideline notes on limitations
associated with the eddy current test method
This Part of EN 10246 specifies the requirements for automatic eddy current testing of seamless and welded tubes with the exception of submerged arc-welded (SAW) tubes for the detection of imperfections. The standard specifies acceptance levels, calibration procedures and gives guidance on the limitations of the tests. This Part of EN 10246 is applicable to the inspection of tubes with an outside diameter equal to or greater than 4 mm. European Standard EN 10246 "Non-destructive testing of steel tubes" comprises the Parts shown in Annex A.
| Committee |
CEN/TC 459/SC 10
|
| DocumentType |
Standard
|
| PublisherName |
Comite Europeen de Normalisation
|
| Status |
Superseded
|
| SupersededBy |
| Standards | Relationship |
| NBN EN 10246-3 : 2000 | Identical |
| NF EN 10246-3 : 2000 | Identical |
| NS EN 10246-3 : 1ED 2000 | Identical |
| PN EN 10246-3 : 2002 | Identical |
| I.S. EN 10246-3:2000 | Identical |
| NEN EN 10246-3 : 1999 | Identical |
| BS EN 10246-3:2000 | Identical |
| UNE-EN 10246-3:2000 | Identical |
| DIN EN 10246-3:2000-03 | Identical |