EN 10246-8:1999
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Non-destructive testing of steel tubes - Part 8: Automatic ultrasonic testing of the weld seam of electric welded steel tubes for the detection of longitudinal imperfections
17-11-1999
01-04-2011
Foreword
1 Scope
2 General requirements
3 Method of test
4 Reference standards
5 Equipment calibration and checking
6 Acceptance
7 Test reporting
Annex A (informative) Table of Parts of EN 10246 -
Non-destructive testing of steel tubes
Annex B (normative) Manual/semi-automatic ultrasonic
testing of untested ends/suspect areas
This Part of EN 10246 specifies the requirements for automatic ultrasonic shear wave and Lamb wave testing of the weld seam of electric welded steel tubes for the detection of longitudinal imperfections. The standard specifies acceptance levels and calibration procedures. This Part of EN 10246 is applicable to the inspection of tubes with an outside diameter equal to or greater than 10 mm. European Standard EN 10246 "Non-destructive testing of steel tubes" comprises the Parts shown in Annex A.
| Committee |
CEN/TC 459/SC 10
|
| DocumentType |
Standard
|
| PublisherName |
Comite Europeen de Normalisation
|
| Status |
Superseded
|
| SupersededBy |
| Standards | Relationship |
| I.S. EN 10246-8:2000 | Identical |
| NS EN 10246-8 : 1ED 2000 | Identical |
| NEN EN 10246-8 : 1999 | Identical |
| BS EN 10246-8:2000 | Identical |
| PN EN 10246-8 : 2002 | Identical |
| NBN EN 10246-8 : 2000 | Identical |
| NF EN 10246-8 : 2000 | Identical |
| UNE-EN 10246-8:2000 | Identical |
| DIN EN 10246-8:2000-03 | Identical |