EN 1071-6:2007

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Significance and use
5 Principle
6 Apparatus and materials
   6.1 Test system
   6.2 Test balls
   6.3 Test slurry
   6.4 Measurement of crater dimensions
7 Preparation of test pieces
8 Test procedure
   8.1 Different types of test
   8.2 Test Type A: No perforation of coating
   8.3 Test Type B: Perforation of coating
9 Analysis of results
   9.1 Test Type A: no perforation of coating
   9.2 Test Type B: perforation of coating
10 Test reproducibility, repeatability and limits
   10.1 Reproducibility and repeatability
   10.2 Limits
11 Test report
Annex A (normative) - Measurement of coating thickness
Bibliography

This part of EN 1071 specifies a method for measuring the abrasive wear rate of ceramic coatings by means of a micro-scale abrasion wear test, based on the well known crater grinding technique used for film thickness determination (see EN 1071-2).This method can provide data on both film and substrate wear rates, either by performing two separate tests or by careful analysis of data from a single test series.The test method can be applied to samples with planar or non-planar surfaces but the analysis described in clause 9 applies only to flat samples. For non-planar samples, a more complicated analysis, possibly requiring the use of numerical methods, is required.