EN 12979:2002
Withdrawn
A Withdrawn Standard is one, which is removed from sale, and its unique number can no longer be used. The Standard can be withdrawn and not replaced, or it can be withdrawn and replaced by a Standard with a different number.
Automotive LPG-systems - Installation requirements
23-01-2002
31-07-2002
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and abbreviated terms
5 Installation requirements
5.1 General requirements
5.2 Connections to LPG-system
5.3 LPG identification mark for M[2] and M[3] category
vehicles
5.4 Changes to the vehicle structure
5.5 Container installation
5.6 Installation of more than one container
5.7 Components on or in the container
5.7.1 General requirements
5.7.2 Remote-controlled service valve with excess
flow valve on the container
5.7.3 Pressure relief valve
5.7.4 Filling unit
5.7.5 80 % stop valve
5.7.6 Level indicator
5.7.7 Gas-tight housing
5.8 Gas pipes and hoses
5.9 Gas connections between components of the LPG-system
5.10 Remote-controlled shut-off valve
5.11 Vehicle connector
5.12 Electrical installation
5.13 Fuel selection system
5.14 Pressure relief device
5.15 Installation manual
5.15.1 General
5.15.2 Contents of the installation manual
6 Markings in case of retrofit installation
Annex A (normative) Definitions of vehicle categories
(extract from Directive 70/156)
A.1 International classification of vehicle categories
A.2 Load and checking conditions
Annex B (normative) Container fixing requirements up to a
capacity of 150 litres
B.1 General requirements
B.2 Container frame
Annex C (normative) Arrangement of approval markings
C.1 Type approval marking
C.2 International country numbers
Annex D (normative) Provisions regarding the identification
for M[2] and M[3] category vehicles
Annex E (normative) Provisions regarding the identification
of the service coupling
Annex F (informative) Installation of more than one container
Bibliography
This European Standard specifies the requirements for the installation of automotive LPG components that comply with prEN 12805 and prEN 12806.These requirements are to ensure safe operation of such components.This standard does not cover type approval of a LPG motor vehicle.NOTEType approval requirements are covered in UN/ECE Regulations and EU legislation.
| Committee |
CEN/TC 286
|
| DevelopmentNote |
Supersedes I.S. 404 (08/2003)
|
| DocumentType |
Standard
|
| PublisherName |
Comite Europeen de Normalisation
|
| Status |
Withdrawn
|
| Supersedes |
| Standards | Relationship |
| NBN EN 12979 : 2002 | Identical |
| NS EN 12979 : 1ED 2002 | Identical |
| I.S. EN 12979:2002 | Identical |
| DIN EN 12979:2002-04 | Identical |
| PN EN 12979 : 2004 | Identical |
| NEN EN 12979 : 2002 | Identical |
| NF EN 12979 : 2003 | Identical |
| BS EN 12979:2002 | Identical |
| UNE-EN 12979:2002 | Identical |