EN 13203-2:2015

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 General test conditions
5 Determination of the energy consumption of
  the appliance
6 Determination of the wasted water
7 Eco design Related Products Data
Annex A (informative) - Test conditions
Annex B (informative) - Test rig and measurement devices
Annex ZA (informative) - Relationship between this European
         Standard and the requirements of Commission
         Regulation (EC) no 814/2013
Annex ZB (informative) - Relationship between this European
         Standard and the requirements of Commission
         Regulation no 812/2013
Annex ZC (informative) - Relationship between this European
         Standard and the requirements of Commission
         Regulation (EU) no 813/2013
Annex ZD (informative) - Relationship between this European
         Standard and the requirements of Commission
         Delegated Regulation (EU) no 811/2013
Bibliography

This European Standard is applicable to gas-fired appliances producing domestic hot water. It applies to both instantaneous and storage tank appliances; waters-heaters and combination boilers that have:-a heat input not exceeding 70 kW; and-a hot water storage tank capacity (if any) not exceeding 500 l.In the case of combination boilers, with or without storage tank, domestic hot water production is integrated or coupled, the whole being marketed as a single unit.EN 13203-1 sets out in qualitative and quantitative terms the performance in delivery of domestic hot water for a selected variety of uses. It also gives a system for presenting the information to the user. The present document sets out a method for assessing the energy performance of the appliances. It defines a number of daily tapping cycles for each domestic hot water use, kitchen, shower, bath and a combination of these, together with corresponding test procedures, enabling the energy performances of different gas-fired appliances to be compared and matched to the needs of the user. Where other technologies are combined with a gas-fired boiler or a water heater to produce domestic hot water, specific parts of EN 13203 apply.