EN 16228-1:2014

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 List of significant hazards
5 Safety requirements and/or protective measures
6 Verification of the safety requirements and/or
  protective measures
7 Information for use
Annex A (informative) - List of drilling and foundation
        equipment
Annex B (normative) - Noise test code
Annex C (normative) - Whole-body and hand-arm vibration
        test
Annex D (informative) - Symbols and signs
Annex E (normative) - Instruction selecting and
        fitting of wire rope grips for free fall
        application
Annex F (normative) - Ground pressure calculation
        for crawler mounted drilling and foundation
        equipment
Annex G (normative) - Test conditions of the stopping
        performances of the rotation of the drilling head
Annex ZA (informative) - Relationship between this European
         Standard and the Essential Requirements of
         EU Directive 2006/42/EC
Bibliography

This European Standard specifies the common safety requirements for drilling and foundation equipment.Part 1 of this European Standard deals with the significant hazards common to drilling and foundation equipment (see Annex A), when they are used as intended and under the conditions of misuse which are reasonably foreseeable by the manufacturer associated with the whole life time of the machine (transport, assembly, dismantling, equipment in service and out of service, maintenance, moving on site, storage, disabling and scrapping).NOTE 1The requirements specified in this part of the standard are common to two or more families of drilling and foundation equipment.This document gives safety requirements for all types of drilling and foundation equipment and is intended to be used in conjunction with one of parts 2 to 7. These machine specific parts do not repeat the requirements from part 1 but supplement or modify the requirements for the type of drilling and foundation equipment in question.For multipurpose machinery, the parts of the standard that cover the specific functions and applications are used, e.g. a drilling machine also used as a piling machine will use the relevant requirements of EN 16228 parts 1, 2, and 4.The following machines are excluded from the scope of this standard:tunnelling machines, unshielded tunnel boring machines and rodless shaft boring machines for rock according to prEN 16191;raise boring machines;drill rigs used in oil and gas industry.NOTE 2Specific requirements for offshore applications are not covered by this European Standard.Where a drilling or foundation equipment of fixed configuration that is not intended to be separated is assembled using a carrier based on earth-moving equipment, agricultural equipment, or a crane, then the completed assembly will conform to the requirements specified in this drilling and foundation equipment standard.Drilling and foundation equipment within the scope of EN 16228 parts 1 to 6 may include interchangeable auxiliary equipment within the scope of EN 16228 part 7, either as an integral part of its construction or as interchangeably fitted equipment.If drilling and foundation equipment is intended to be used in a potentially explosive atmosphere, additional requirements will need to be met which are not covered by this standard.